You probably have a clogged filter. The filter is a made of wire mesh that is molded to the approximate dimensions of a thimble. Becuase the wire mesh of the filter is very fine, it is difficult to clean. Order a replacement from the manufacturer. Be sure to shut the water off and remove the hose. There are sometimes small screen filters on the hoses, and always a screen filter on the infeed to the washer where the hose connects. Check the filter. Even a little bit of build-up can cause severe issues with fill time. My washer was taking close to an hour to fill on cold, and now fills in 2 minutes since changing the filter.
There are a few reasons why your washing machine is not filling up with hot water. A tube could be plugged. There may also be an issue with the hot water heater. Have a professional check the machine.
the water calve could be going bad or you could have a siphon happening from the drain line.
The water cut off device is stuck in the full position. -You don't say what kind of machine, or else I could tell you how to fix it.
Operating a washing machine is pretty simple:There are a few things to decide before you start your load of clothes, such as how big the load is (small, medium, large, extra large), what temperature the water will be for the wash and rinse cycles (cold/cold, warm/cold, warm/warm, hot/cold), how the machine should agitate (delicate, knit, permanent press, heavy), and how long the cycles should last (number of minutes, based on how soiled your clothes are).After you fill the tub with clothes, the machine fills the tub with water, and then stirs the clothes around using an agitator.After some time agitating, the washer drains the water and then spins the clothes to remove most of the water. Then, it refills, and agitates the clothes some more to rinse out the soap. Then it drains and spins again.
it could be from the hot water heater if it's not turned off. hot water expands pushing out more water when cool the heater can suck in air to fill the voide.
There are a few reasons why your washing machine is not filling up with hot water. A tube could be plugged. There may also be an issue with the hot water heater. Have a professional check the machine.
Well, maybe you just have a really bad washing machine
63
Yes, my machine has a hot fill.
the water calve could be going bad or you could have a siphon happening from the drain line.
The water cut off device is stuck in the full position. -You don't say what kind of machine, or else I could tell you how to fix it.
If your Whirlpool washer is leaking at water fill period, check to make sure that the hoses are tightly connected. They can sometimes loosen over time.
The washer drain is partially clogged or too small and the sink is the easiest place for the water to go.
1920's washing machines didn't have a lid. You would have to get the hose from the garden and fill the washer machine up!
Backflow from the sewer or drain pipes.
Modern washing machines have sensors to make sure the amount of water used is correct. If the question is just a theoretical question than the clothes will trap air and so it will be more difficult to fill if there are clothes with as much water compared with filling an empty tub.
Use a shower instead of a bath Buy a new toilet if you have an old toilet Turn the taps off if they are not needed Fill the washing machine to the top