cold solvent cleans the crystals - without dissolving them.
The collected crystals in a recrystallization process are washed with cold water to remove impurities and excess solvent without dissolving the desired crystals. Cold water helps to minimize the solubility of the crystals, allowing for a more effective purification process.
Some helpful recrystallization tips for obtaining pure crystals include using a suitable solvent, slowly cooling the solution to allow crystals to form, filtering the solution to remove impurities, and washing the crystals with cold solvent to further purify them.
You can use a solvent such as a mixture of dichloromethane and methanol to recrystallize a Mn-salen complex. By dissolving the complex in the hot solvent mixture and allowing it to cool slowly, crystals will form, which can then be filtered and washed to obtain the purified product.
Crystals are washed with cold water during recrystallization to minimize solubility, reducing the risk of losing product through dissolution. Warm water can dissolve more impurities along with some of the desired compound, leading to lower yield and impure crystal formation.
Usually, solvents at lower temperature can dissolve lower amount of crystals than solvents at higher temperatures. For eg. if impurity is salt then you are better off washing it at a lower temperature as salts have a good solubility even at lower temperatures and as you raise temperature your crystals will start dissolving in the warm solvent.
To recover solid silver nitrate from a reaction mixture, the solution needs to be evaporated to dryness to remove the water content. This will leave behind solid silver nitrate crystals that can then be collected by filtration. The crystals can then be washed with a small amount of cold solvent to remove any impurities before air drying.
To recrystallize benzanilide, you would first dissolve it in a hot solvent (such as ethanol) until it forms a clear solution. Next, slowly cool the solution to allow crystals to form. Filter the crystals, wash them with a cold solvent to remove impurities, and then allow them to dry to obtain pure benzanilide crystals.
It depends on the type of crystal. Some crystals are soluble in hot water but not in cold water, while others may dissolve in cold water but not in hot water. It's best to consult the specific properties of the crystal you are working with to determine the appropriate solvent.
The compound that you are trying to recrystallize is soluble in hot solvent but relatively insoluble in cold solvent. You also must remove an impurity that is insoluble in hot and cold solvent. The first filtration (a hot filtration) is to filter out the impurity. The second filtration (a cold filtration) is to filter out the (hopefully pure) recrystallized compound.
Dissolve the impure solid in a hot solvent. Filter the solution to remove insoluble impurities. Allow the solution to cool slowly to encourage crystal formation. Filter the crystals, washing with a cold solvent to further purify. Dry the purified crystals to obtain the final product.
cotton should be washed with cold water
You If You Still have the cold, No. If you barely recovered then yes.