Cut the Wire was created in 1987.
You Should Cut The Yellow Wire! : D
Just use some wire cutters or sharp scissors & cut (only until you feel wire)while you rotate around. Once you cut all the way around, pinch where you cut (carefully)with implement & pull off insulation. It takes a little practice,& occasionally you will go thru wire as well, but that's how it's done.
Phisical
you take the blue wire and connect it with the red then connect it to the yellow then you cut the green wire and there you go!
EDM wire cutting
EDM works by creating thousands of sparks. The sparks melt or vaporize the material instead of cutting it. This process works best on non-ferrous metals, such as steel.
Wire EDM uses a thin wire to remove surrounding material, where conventional EDM uses a shaped electrode to remove material.
I can think of two different things this might be: 1. Dies can be used to make wire. The wire is pulled through a smaller hole to make a thinner wire. The tool with the small hole would be a die. 2. You might be referring to wire EDM (Electrical Discharge Machining). This is a way of cutting metal with electricity. It is often used in the fabrication of dies because it can cut through the hardest metal - metal that is too hard to cut with normal cutting tools.
an edm is a electrode discharge machine. it uses electicity through an electrode to precision cut metal submerged in oil.
a serrated wire used to cut through small bones
what is the purpose of edm
"I used the pliers to cut the wire"
YES ! It is actually possible to die of boredom. GET OUT NOW BEFORE IT'S TOO LATE !
this tools can be used to cut wire , small screws
Cut the Wire was created in 1987.
You Should Cut The Yellow Wire! : D