0
First, check Transmission Fluid levels, but typically once you loose a full gear, if the fluids topped off, your looking at a transmission rebuild.
What else can I help you with?
Where is a thermostat in a Chevy Beretta v6?
I'm looking where the therma stat is location in a 1996 Chevy bratta at
How do you adjust timing on a 3.1 Chevy Beretta 1996?
Computer controlled and not adjustable
1996 Chevy beretta leaks at the bottom is it the slave cylinder?
oil leaks
Where is voltage regulator located on 1996 Chevy beretta?
The voltage regulator is built into the alternator.
What is the torque for the head bolts for a 1996 Chevy beretta 3.1 4 cylinder?
The 3.1 was a V6
How do you open the trunk without the key on a 1996 Chevy Beretta?
fold rear seat down pop from inside...
What is the cost of replacing a fuel pump on a 1996 Chevy Beretta?
I'm replacing the fuel pump in my 1996 Chevy beretta Z26 right now and so far I have spent $286.36 on the pump and $4.40 on a new retianing ring. I will still need to buy a fuel filter should be under $10.00.
Where can you find PCV valve on 1996 Chevy Beretta?
if it's the 3100 V6, it is on the right side of the front valve cover
Locate fuel pump reset button on 1996 Chevy Beretta?
GM vehicles do not use inertia/reset switches.
Where is the engine block drain plug located on a 1996 Chevy Beretta Z26 besides just on the bottom?
A 96 Chevy Beretta Z26 has a 3100 V6 engine. The oil drain is located on the bottom of the oil pan, on a slight angle pointing down and towards the rear.
How do you open a trunk of a 1998 Chevy Barretta when the cylinder has been knocked inside the trunk?
First of all you can not have a 1998 Beretta because they stoped making them. So good luck in 1996. Remove the back seat. DoratheExplorer first you learn how to spell beretta, then you stop disgracing the name, and then hit the curosity button in the center consol
Where is the fuse for the generator under the hood of a 1996 Chevy Beretta?
there is a fusable link in the wiring, but no actual fuse. the fusable link is down by the starter assembly...
