0
Why is your 2001 Alero service engine light on trac off light and the ABS light on?
Wiki User
∙ 14y ago
hubs
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Is the service engine soon light on 2001 S10 same as check engine light?
Yes, the Service Engine Soon light is the same as the Check Engine light.
How do you reset the service engine soon light on a 2001 ford pickup?
why appear light ( service engine soon), after change oil on a 2001 ford pickup (f150)?
How do you reset the service engine light on a 2001 alero?
On the driver side when you open up the door look at the end of the dash...there is fuse door open it and hold down the red reset button till the light come off.
Service engine soon light 2001 Silverado?
The vehicle is due a service soon
What does the low coolant warning display light look like on a 2001 alero?
I have a 2002 alero how do you reset, the coolant light is always on. Thanks, Alero owner
2001 Mitsubishi mirage service engine light wont start?
If the 2001 Mitsubishi Mirage won't start and has the service engine light on, you probably have an issue with a sensor. This could be a problem with an electrical or oxygen sensor.
Turn off change oil light in 99 olds alero?
how to get the check oil light to go off on a 2001 olds alero
Where is the oil pump located on a 2001 alero?
In the engine oil pan.
How do you reset service engine soon light on 2001 Chevrolet silverado?
That requires an OBDII engine scanner.
Where is the Low side service port for ac 2001 alero?
The low side service port for the AC on a 2001 Alero is located on the hose that runs from the accumulator to the compressor. It is the larger of the two hoses coming off the compressor.
What does service engine soon light on a 2001 Nissan Xterra mean?
Emissons problem
How can you reset the service vehicle soon trac off and anti lock lights on 2001 alero?
On my 2000 Alero I open drivers door and open fuse panel door. Then turn key onposition but don't turn engine over. Push in reset button until the light you want flashes then hold the reset button for a few seconds.
