answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Why is your 98 z28 not burning out like it should you?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Horsepower does a 98 camaro z28 have stock?

305


Will 98 camaro leather seats fit a 94 z28?

No


Can i replace the 4L60 trans in my 96 camaro Z28 with a 4L60e trans out of a 98 Z28?

The Camaro started using the 4L60-E in 1994, so that's what your 96 Camaro should be set up for already.


What cars are faster than a camaro z28?

For the money a 93 and up 6spd corvette should get you by the z28... off course any year viper or corvette zr1 will do the trick. 93-98 supras too.


Where is the intake air temperature sensor on a 98 camaro z28?

It should be in the tubing in the air filter running into the throttle body. They are usually after the air cleaner.


What transmission is used in a 98 z28?

your transmission may only be two types a six speed or a 4l60e


What is the gear ratio in a 98 camaro Z28?

Depends on the engine and transmission. It should be in the manual. Call the dealer with your Vin#. They should have it. Or it should be on the tag on the rear end cover held on by a bolt. It was on older cars. I am not sure on your though...Hope it helps..


How many oxygen sensors does a Chevy Camaro 98 have?

It may depend on whether or not it is a Z28, SS etc. I have a V6 98 and it has 3. 2 right after the headers and 1 by the cat.


How cold or hot is 98digress f?

98 degrees is burning hot u should wear shor ts tank top and flip flops its so hooot its like a heat wave hit


Will a air conpressor on a 98 Camaro v6 fit on a 93 Camaro z28?

dont think so it should be a different bolt pattern if needed just cross reference part number on autozone.com to see if there the same


What causes a humming sound in the rear end on a 98 z28?

may be a bad or worn ring and pinion gear axel brgs' or low gear oil


The shop manual for your '98 z28 states that you should use the ac 41-931 plugs while the parts store claims they should be 41-985; what is the difference of using 985s vs the 931s?

The 985 plug is meant to run slightly hotter then the 931 plug. This is a higher performance plug.