answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Why is your starter pull chord so hard to pull?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Natural Sciences
Related questions

The locking mechanism is so the chord doesn't get detached if you move around a lot and accidentally pull on the chord. But you will have to screw in the locking chord. The non locking looks better.?

The locking mechanism is so the chord doesn't get detached if you move around a lot and accidentally pull on the chord. But you will have to screw in the locking chord. The non locking looks better.


If a radius of a circle is perpendicular to a chord at what point does it intersect the chord?

The radius of the circle that is perpendicular to a chord intersects the chord at its midpoint, so it is said to bisect the chord.


What is a bell chord?

A bell chord is a musical chord which is played as a sequence of single notes on multiple instruments, sustained so that the chord can be heard.


What are chord inversions?

When you invert a chord, all that you are doing is taking the third or fifth of that chord (so if it was a C chord, an E or a G), and you make that note the bass note. It gives the chord a bit of instability. Having the fifth especially does so.


Why is it so hard to fool a snake?

because it has no legs to pull


Why does your s-10 starter keep turning after the motor has started and you have to pull the starter relay to stop the starter?

This usually means a sticking solenoid that keeps the starter engaged after activation. The fix is to remove the starter and clean but my s-10 starter is a closed unit so you will have to replace the complete starter and solenoid unit.


How to install a starter for a 1995 Mitsubishi 3000 GT 5 speed?

I just changed my clutch in my 95 VR-4. I Hope this is helpful, I had to pull the starter to pull the tranny so here ya go. first disconnect your power from your battery. Your starter is in the front bottom center of the motor. Mine had a heat shield protecting it from the exsaust. What you can do is pull the two screws out of the heat shield that should give you access to the starter. I don't know for sure buy you may have to pull the exsaust, I had to pull mine to remove my left driveshat. After that take off the power cable and the ground cable should just pull off. there are Two bolts that hold your starter on and they go through the bellhouse of your tranny. Your starter is very easy to change compared to a cluth.


Who is Sam Evans from Glee dating?

I think it's Austin butler but I'm not sure. No, his name is Chord Overstreet


For a Chevy truck how would you hard wire a start and kill switch fro starter to electronic ignition to the cab?

I have a 93 chevy pick up all I want is to hard wire the starter so the the truck will start with just wire straight from the starter to battery


How is a diameter a chord and a chord not a diameter?

Every chord is a line on the inside between two points on the circle. A diameter does that, so it's a chord. But in order to be a diameter, a chord also has to meet another requirement ... it has to go through the center of the circle. A lot of chords don't do that, so they can't be diameters.


I wanna know if I apply for AT and T 2 year contract they gonna do a credit check So is that a hard pull or a soft pull on my credit?

If you apply for a 2 year contract with AT&T they will do a hard pull on your credit report.


Does a smith and Wesson 40ve have a safety?

no it does not. that's why the trigger pull is so hard..