The frequency is too low.
For satllite communication the frequency should not be less than the critical frequency because in satellite communicaton high frequency is needed which is reflected by satellite but not by the ionosphere.
Your communications with a satellite are by the use of microwaves. High frequency em waves.The distance to your local transmitter will most likely be much less than to a satellite, and transit delays will be shorter.The speed of the comms media is essentially at the speed of light - the only difference is the distance.
It means "ultra high frequency" and is a analog channel. It's what you watched on TV before cable or satellite. The other type was vhf or "very high frequency".
The downlink frequency to Earth, in the context of communication satellites or spacecraft, refers to the frequency at which data is transmitted from the satellite to Earth. The specific frequency used can vary depending on the satellite system and the communication protocol being employed. Generally, downlink frequencies for satellite communication are in the microwave frequency range, typically between 1 to 50 GHz. The choice of downlink frequency is influenced by factors such as transmission range, atmospheric absorption, and regulatory requirements.
High frequency is used because of the the size of antennas used to transmit and receive the communications signal. The higher the frequency the smaller the antenna.
Every information sent and received through satellite communication has to have an address to enable the communication process of signal delivery and reception. This naming of the signal is made in the form of a specific frequency. For example each TV channel operates on a unique frequency of it's own. When that frequency is called (tuned technically) out of a spectrum in that band, the chosen frequency gets selected. Since satellite transponders operate at very high frequency, modulation of the signal on to the carrier is difficult. Hence modulation is carried out at a much lower frequency. Such modulated signal is raised to the required frequency( name or address as stated above) that supports the satellite band and the transponder. The equipment used to elevate the frequency of the low frequency carrier (known as Intermediate Frequency) to the satellite transponder frequency is UP CONVERTER C.K.Vasudeva Bangalore
CBs, or Citizen's Band radios, are two-way radios that operate on a specific set of frequencies designated for civilian use. They are commonly used by truckers, off-road enthusiasts, and emergency services for communication over short distances. Military entities may also use CB radios for non-sensitive communications in certain situations.
Applications: They are used in low power amplifiers DLVA, microwave and RF power monitors, high-frequency triggers, ALC loops, zero bias detectors, ACP tunnel diode circuits, etc. Since they are more resistant to nuclear radiation, tunnel diodes are used in space applications like amplifiers for satellite communications.
These are frequencies used for satellite communications. Usually in the Gigahertz bands. Uplink is on a differenct channel to downlink, to avoid interferece. The Uplink, is the signal sent to the satellite, via a dish antenna, which focuses the signal in the direction of the satellite. On board the satellite, this signal is changed and re-transmitted, on a different frequency (Downlink), and beamed back to earth. This way huge distances can be covered on earth, despite the curvature and with minimal power.
High capacity Wide area coverage Highly reliable Supports different kind of applications( like, communications, broadcasting, navigations, meteorology etc.)
Perhaps, you misspelled it. It should be Ku band, a high frequency band used for beaming satellite signals, including Television channels.
Shahid Ahmed Khan has written: 'Extra-high frequency line-of-sight propagation for future urban communications'