0
A pipe inside the rear hatch has diconnected, simply remove the plastic inner panel inside the hatch and reconnect
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
Fitting instructions to replace fiat punto rear wiper arm?
how do get rear wiper arm off fiat punto grande
Where are the wires for the rear speakers in a standard 2000 Fiat Punto?
If you have a Fiat Punto 2000 S, there may not be any rear speaker cables, I know there wasn't in mine.
Need nuts for rear lights on punto?
where can i get car nuts for cluster rear lights for fiat punto 51 year
How does the washer motor on Fiat Punto decide to send water to front or rear washer jets?
There are two separate feeds from the washer tank. To access the washer tank you have to unscrew the trim under in the wheel well and pull it away. To do this you have to take the wheel off.
How do you adjust rear brake drums on 1995 fiat punto?
what are the pins for on a wheel drum?
What is the tire pressure for a Fiat Punto 1.2?
Tyre Pressure for Fiat Punto 1.2cc 8V 3 door is 29psi (front) or 2.0 bar 28psi (rear) or 1.9 bar for normal use.
Where can you find rear brake self adjuster spring for fiat punto 1.2 16v elx 2001?
Nowhere
Where is the fuel filter located on a 1995 Fiat Punto?
it's located under the rear drivers side wheel arch
Location of rear wash bottle fiat punto?
Mk 1 (1993-1999) Punto doesn't have a separate one. It's the same as the one for the front (loated in the engine compartment). There is a tube inside the boot lid that sometimes comes loose, so the rear washer doesn't work, even with fluid in the bottle. takes two minutes to re-attach. Just remove the inner panel of the boot lid and you'll see it.
Where is the location of the fuel pump relay on a fiat punto 1995 55 sx thanks?
Under the rear seats. Remove 3 screws from the metal plate and there it is.
On my fiat punto the rear wiper only works when it wants to but recently is not working at all can anyone help?
i would check for loose wires first then check the switch
Change rear brakes on fiat punto 1995?
quite straight forward- take off the hub first much easier - make sure you photo or draw where the springs go -- blueson 44
