answersLogoWhite

0

it can exchange the current is much larger and has Avery low resistance when it is turned on.the mosfet is not removed from the circuit when the supply is on because it flow the high current.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What are the Advantage of mosfet over fet?

MOSFET has high input impedance and offer input signal isolation from the circuit


What is the circuit diagram of MOSFET as a variable resistor?

It is here at this website. www.mosfetdiagrams.co.uk/varibles


Use uc3707n FOR 500W mosfet power amplifier circuit diagram?

not yet


Can we replace a thyristor by a mosfet?

No because a mosfet does not work the same as a thyristor. In a thyristor the current flows even when the gate pulse is removed, until the current stops. That is not the case for a FET.


What is the function of enhancement mosfet?

An enhancement MOSFET doesn't conduct current across the drain to source unless a voltage is applied to the gate. When sufficient voltage is applied to the gate of the transistor, currents flows from drain to source. A MOSFET acts as a switch or amplifier in a circuit.


Why mosfet has insulated gate?

The SiO2 layer acts as an insulator and also it provides high input impedance to the MOSFET. This insulation is needed so that a circuit with high EMI or loads which generate back emf (motors) can be driven by applying gate current from a common circuit.


What is NMOS in electronics?

when n- channel mosfets are used to construct a circuit these are called nmos(N- channel mosfet).


The dc input resistance of MOSFET is?

it depends on the type of the circuit you are analyzing..it could be a voltage divider, emitter follower, be specific on what type of circuit and maybe i can help you aobut this question.


What is a mosfet amplifier?

what is a mosfet amplifier


Can you replace mosfet with an bjt transistor?

A MOSFET (metal oxide semiconductor field effect transistor) can be used INSTEAD of a BJT (bypolar junction transistor, so transistor is redundant in your question), if the circuit in question is modified to allow it and the MOSFET is chosen appropriately. BJT's will usually have a higher intrinsic gain, but have lower input resistance. Also a BJT in general will work better at higher frequencies than a MOSFET (unless you choose a high frequency MOSFET) due to the capacitive nature of MOSFETs.


What happens if the resistor in RC circuit is removed and the capacitor is directly connected to power supply?

If by power supply you mean a voltage source, it really won't matter that the resistor is removed. The voltage source will provide infinite current, instantly charging the capacitor so that the capacitor's voltage is equal to the source.Alternative AnswerIf you are referring to an a.c. circuit, then a load current will continue to flow with its value being determined by the capacitive reactance of the circuit, and the resulting phase angle will lead the supply voltage be very close to 90 degrees.


Alpine amplifier wattage for MRV-F300 V12 duo B circuit used older amp?

This type of amplifier has 75W x 4, V12 High Power Amplifier, MOSFET Power Supply, Non-Fading Pre-Amp Output, and Bass Engine.