The set on the teeth makes the kerf (width of the cut) slightly wider then the blade so the saw can clear the dust from the cut and the blade won't bind up.
It will have bigger teeth or less teeth per inch and should have a wider set to the teeth.
It is the displacement of teeth on the saw, i.e., to bend the teeth of the saw alternately to either side of the blade. ( then I noticed this is in a computer section, sorry).
You must mean 'Bevel' and that's the angle the saw is set at.
It is called "set" in the teeth. It takes a the sawdust out of the cutting surface so the saw will not bind as much.
No, it does not. The term describes the saw blade itself, which usually has finer teeth with little or no "set" to the teeth. A crosscut saw may be a hand tool or a power tool. ***SAFETY NOTE: Installing any saw blade backwards on any power saw is NOT recommended.
Start the saw without the blade for a split second to see which direction it spins. The saw blade teeth should point in the same direction. The points of the teeth are the part that should strike the wood first.
A backsaw can not cut metal as the 'set', 'pitch' and size of the teeth are for fine woodcutting.
Insects and birds have no teeth.
Yes they do, all teeth have a second set of teeth
Yes they do, all teeth have a second set of teeth
Baby teeth, milk teeth or first teeth. Baby teeth, milk teeth or first teeth.
A saw.