if you look on the bottom track there is a little rubber bump in it. On your van it must be almost flat. it is supposed to poke up like an upside down V.
Mine has the same problem and although I have tried to get it to stick up again, it may have to go to a mechanic who can replace the rubber bump.
http://KevinsCamera.com
If the sliding door on the 1999 Mercury Villager will not stay open, check for something that is not allowing the latching mechanism to lock into place. Make sure that the door is all the way back so that it can lock in.
There is no way to do this. There are child-proof locks on the sliding doors.
If it's the opening type, unscrew the latches and take it off.
The door jamb is the area around the inside of a door opening.
Take it to a dealer.
Your correct tire size is on your door sticker.
Tire sizes are on the door jamb sticker.
The 2000 Mercury Villager front door panels are held in place with two retaining bolts and eight retaining clips. Remove the retaining bolts and pry outward on each retaining clip.
The button is right below the seat ontrols
On a 1997 Mercury Villager open the drivers door and on the latch pillar you will see an information sticker that shows the original size tires on the vehicle from the factory
The trim pieces are different.
no