answersLogoWhite

0


Best Answer

does your car have a sensor in the dash or anywhere else for automatic lights on and off, it looks like a small ball. it works off of the same principle as a night light, when it is dark enough it the lights will come on, and vice versa, so check to see if you have one or if there is any papers on the dash clean it off. if this does not work and you so have a sensor like the one I described, it is probably bad

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why on a 1991 Volvo 240 exterior lights will not turn off headlights tail lights licence plate light unplugged headlight switch it did nothing need to disconnect bat cable to shut them off?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

The headlights on your 1995 es300 are dim- you have polished the exterior covers still dim?

These are projector headlights, not regular reflectors. you must polish the inner lenses as well-- these are the two spheres visible inside the headlights. open headlight case and polish away. Ajax followed by whitening toothpaste works.


What is a cheap alternative to costly headlight cleaner products?

A cheap alternative to costly headlight cleaners is toothpaste. Cleaning the interior and exterior of your headlights with toothpaste will leave them clear and shiny. The grit in the toothpaste helps remove dirt and bug residue that accumulates while driving. It is a great cost effective means of cleaning your headlights. Toothpaste averages about 1.50$ per tube and will last you through various cleanings.


Why would your headlights and dash lights blink on 1999 Geo Tracker?

Blinking lights on dash and exterior lights may indicate a bad ground wire or a faulty headlight switch. Both would cause those problems.


How far away should the disconnect switch be located from an exterior hot tub?

5 feet


1996 ram driving lights relay located?

The exterior lights do not have a relay. They are directly turned on by the headlight switch.


Exterior electrical disconnect is required in sight of what?

It is usually expressed the other way around. The electrical disconnect has to be within 20 feet and line of sight of the equipment you are working on.


Exterior compressor is missing the breaker at the exterior service disconnect The Heat which is also effective by this also didn't operate what problem?

It sounds like one leg of your service distribution is open.


How do you replace the passenger side mirror on a 2005 Ford Focus?

Removal and Installation Remove the trim panel. Release the clip. Release the locating tabs. Remove the trim panel. Disconnect the exterior mirror control switch electrical connector. Disconnect the exterior mirror electrical connector. Release the clip. Release the electrical connector. Disconnect the electrical connector. Remove the exterior mirror. Remove the bolt. If equipped, remove the screw. To install, reverse the removal procedure.


How do you remove a Lexus RX headlight glass?

the headlamp glass is a non serviceable item, you can not disassemble the plastic exterior from the headlamp module. if your exterior lens is foggy from uv discoloration you may find after market products to clean and restore the clear lens.


What does the light bulb on the dashboard of a Mercedes c280 mean?

the light bulb on you dashboard means you have and exterior light out if it isn't you headlights blinkers....ect its probably just a short


An air conditioner should have an exterior disconnect located where?

The definative answer to this question should be located in the NEC, but I would say within sight and reach of the condensing unit.


Exterior electrical disconnect required in sight of the what?

If it is a swamp cooler no if it is a condensing unit then yes. In sight is described as being within 50 feet with clear visibility