0
Why on a 98 achieva brake lights not coming on switches at pedal are working the light in the rear windshield works is there any other relays between the switch at the pedal and the tail lamps?
Wiki User
∙ 16y ago
Check for burned out bulbs Check for a broken wire between stop light switch and brake lights Check for corroded light sockets
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Windshield wipers not working?
Windshield wipers don't work
The windshield wipers on a 1991 Nissan sentra do not start what might be the problem?
Windshield wipers not working on a 1995 Nissan sentraTry the panel between the hood and the windshield. that is where the linkage is located. I have had problems where the linkage has broken. and the wiper will not work at all
Switches not working properly air condition?
switches for my aircondition Isuzu ascender
Why did the windshield wipers quit working on a 1993 Chevy Cavalier?
The most common cause that windshield wipers stop working is a blown fuse. The windshield wiper motor may need to be changed is also common.
What causes windshield wipers to stop working?
Windshield wipers are an important safety feature on cars. They stop working when their motor goes out, or when the blade is too worn out.
Dodge ram1500 windshield wiper not working?
My be fuse
Why would the brake lights on a 1995 Olds Achieva S quit working?
Check the switch on the pedal
What would cause the windshield wipers on a jeep wrangler Sahara to stop working?
Fuse or windshield wiper motor.
Why might windshield wipers stop working?
your windshield wiper motor might burnt out or a fuse might burnt out
Why does your heater occasionally stop working and there is water on the floorboards on a 95 olds achieva?
you need to replace your heater core.
What does a solenoid do on a riding lawnmower?
It works as the connector between the battery and the starter. When the key is turned the solenoid makes the connection between those two cables and allows the engine to crank over. If the mower is equiped with safety switches they override the connection and keep the solenoid from working until all the switches have been closed.
I have two lamps with broken switches - can just the switches be replaced?
Yes, you should be able to just replace the switches and get the lamps working again. Go to your local hardware store and they can give advice.
