0
A fault can be resistive in nature, and the amount of resistance in the fault is unpredictable. It is unusual for a fault to be inductive or capacitive, so a typical method is to determine the impedance to the fault, and compare only the inductive part of this to the inductive part of the line impedance.
What else can I help you with?
What is a bad connection in an electrical circuit called?
"A wiring fault" which - depending on the actual behavior of the bad connection - might also be described as "an intermittent fault", "a high resistance fault", or a combination of all three terms. For example: "An intermittent, high resistance wiring fault".
Is internal resistance of a cell a defect or not?
no internal resistance of a cell cannot be considered to b as a defect because the resistance is so small as compared to the output we get from a cell this ristance can be neglected..
Fault finding in colour tv receiver?
what are the possible fault in colour tv transmitter and receiver?how we can overcome this fault?
What will happen to the bottle if air resistance is neglected?
If air resistance is neglected, the bottle will fall with the same acceleration as any other object due to gravity. Without air resistance, the bottle will accelerate downwards at a constant rate of 9.81 m/s^2 (assuming no other forces are acting on it).
What is fault resistance?
Not all 'short circuits' are 'dead-shorts' -i.e. the resistance between the two conductors (or a conductor and earth) is not necessarily zero ohms -especially when the insulation between them has not completely broken down. The actual resistance is called the 'fault resistance'.
What is the unit substitution fault finding technique?
Unit of fault level is KA. Kilo amps
How frictional resistance along a fault affect the force released during an earthquake?
Higher frictional resistance along a fault can inhibit the fault from slipping smoothly, causing stress to accumulate over time. When this stress is eventually released as an earthquake, the force released can be higher if the resistance was greater. Conversely, lower frictional resistance can allow the fault to slip more easily, potentially leading to a lower force released during an earthquake.
How do you locate fault using whetstone bridge?
To locate a fault using a Wheatstone bridge, you first connect the bridge to the circuit where the fault is suspected. By adjusting the bridge until it is balanced (indicating zero voltage difference across the galvanometer), you can determine the resistance values in the circuit. If the bridge remains unbalanced, the difference in resistance can help identify the location of the fault by comparing with known resistance values. The point where the fault occurs can often be inferred from the changes in resistance readings throughout the circuit.
Fault finding name for tycoon?
Robber Barons
Fault-finding name for tycoon?
Robber Barons
What is the synonym of finding fault with?
One such word is criticize.
What is the purpose for finding temperature coefficient of resistance?
to investigate change in resistance as temperature is varied
