You need to find out if the problem is internal or external. A repair person would check to see if power were getting to the dryer with a volt meter. If there were no power at plug the problem could be a tripped breaker or an open wire.
If there was power to the dryer there could be a separate dryer reset button on the unit. Check your manual.
Otherwise, you would have to check for internal wiring problems. Look for black areas around wiring or components where some type of electrical problem caused an open circuit. You basically have only three main things that can be bad, the motor that spins the drum, the control unit and the heat producer (gas or electric). Also look for an interlock switch on the door if the controller seems to be okay, but the unit won't spin the drum.
The more information you can give in a case like this, the more targeted the answer can be.
No, an electrical starter can not turn without an electrical source.
An electrical motor generator in reverse means that it can turn the electrical energy to mechanical and kinetic energy.
No, it opens the circuit so that no current flows.
because the water is turn off
There are a couple ways to vent a dryer, my personal favorite is the dryer vent vacuum. They also have dryer vent hoods, and kits available for installation that will increase the effectiveness of your dryer.
Yes
Well the first electrical dryer was first created by Mr. Mike Hunt but assisted by Mike Ocksbig.
A typical hair dryer is powered though household electrical currents.
yoy
with a bannana
How do the wires connect on a 3 prong electrical cord on the lde8414ace maytag dryer
electrical to heat and mechanical
my clothes dryer wiil not stop when the time has expired
An electrical plug for a clothes dryer can be bought in most general hardware stores or even in some department stores with a reasonable hardware department.
It's just because pockets can turn inside out from the action of the dryer. Some clothes dry best if they are put into the dryer inside out anyway.
A space of 30 inches or the width of the electrical equipment is needed, whichever is greater, for electrical equipment.
electrical or potential (gas) to heat.