since the iron loss depends only on the volage and frequency,the supply volage is 230v ac.Hence iron loss is always constant
Iron losses are due to energization of the transformer; they do not depend on the loading of the transformer. They will vary depending on the voltage applied to the transformer. The best model of this is a parallel connection to the ideal transformer winding.
Constant losses Those losses in a d.c. generator which remain constant at all loads are known as constant losses. The constant losses in a d.c. generator are: (a) iron losses (b) mechanical losses (c) shunt field losses
Iron losse are constant at all different levels of speed
eddy current can be reduced by using laminated cores. and also be reducing the thickness of the stampings. transformer iron loss is the combination of eddy current loss and hysterisis loss. both the losses depend on core of the transformer and iron loss is a constant loss.
The transformer can be tested on open and short circuit to find the iron losses and copper losses separately, which uses a fraction of the power than having to run the transformer on full-load.
because iron loss is depends on frequency and it is constant through out the operation ...irrespective from load
Iron losses are due to energization of the transformer; they do not depend on the loading of the transformer. They will vary depending on the voltage applied to the transformer. The best model of this is a parallel connection to the ideal transformer winding.
The transformer will have the maximum efficiency.
Constant losses Those losses in a d.c. generator which remain constant at all loads are known as constant losses. The constant losses in a d.c. generator are: (a) iron losses (b) mechanical losses (c) shunt field losses
Iron losse are constant at all different levels of speed
Copper losses are directly related to loading of the transformer. Iron (core) losses are a result of magnetizing of the core of the transformer, and are relatively constant from no load to full load. With this in mind, it should be clear that the above statement is false. Maximum efficiency results with low core losses, and low copper losses. Copper losses cannot be helped, so it is important to minimize core losses to increase the efficiency of a transformer.AnswerYes, it is perfectly correct -well, with the proviso that transformers normally operate somewhat below full load and, so, are designed to achieve maximum efficiency somewhat below full load. A transformer's maximum efficiency does indeed occur when the copper losses and iron losses are equal. Unfortunately, the mathematical proof of this is too complicated to reproduce here, I suggest that you check out any reputable electrical engineering textbook.
eddy current can be reduced by using laminated cores. and also be reducing the thickness of the stampings. transformer iron loss is the combination of eddy current loss and hysterisis loss. both the losses depend on core of the transformer and iron loss is a constant loss.
The transformer can be tested on open and short circuit to find the iron losses and copper losses separately, which uses a fraction of the power than having to run the transformer on full-load.
To reduce heat generated and eddy current losses in transformer's core during operation.
That is to reduce eddy currents, and therefore, transformer losses - since the eddy currents are wasted energy.
because of its losses i.e iron and copper losses. since iron loss depends on voltage (v)and copper loss depends on current(i).
Basically two types: 1. Copper losses:- when the transformer is loaded, current flows in primary and secondary winding, there is loss of electrical energy due to the resistance of the primary winding, and secondary winding and they are called variable losses. These losses depend upon the loading conditions of the transformers. Therefore, these losses are also called as variable losses. 2. Iron losses or core losses:-The losses that occur in the core are known as core losses or iron losses. Two types of iron losses are: > eddy current loss > Hysteresis loss.