0
sorry for my bad english, 1. see after that the largest cabel to the starter, dont is conected (shortcutted) to the smaller rellay innput ( 15) on the starter rellay. if the cabel is fix it. The onley way a starter could run is if it gets + on 30 and 15 at the same time, so look after the two cabels and look for shortcutting.
What else can I help you with?
After trying to start and engine what would cause it to keep turning over even when you disconnect the ignition wires all to gether?
your starter is bad, has a short in it, or is sticking, you might be able to get the starter tested without taking it off your vehicle.
Would the ignition switch control the dash lights?
It sends a power to the starter relay/solenoid to engauge the starter. Know that the ignition switch is not what you put the key in and turn. That is the lock assembly. The ignition switch is located lower down on the steering column.
How do you bypass a starter solenoid?
A starter solenoid can be bypassed by connecting a jumper wire between the battery and ignition posts on the starter. This will cause it to spin immediately without using the ignition switch.
Why would the starter try to engage while the engine is already running?
If you're implying that it engages without you turning the key, the problem is one of the following: * a faulty wire somewhere, * the starter solenoid was connected wrong * or the solenoid return spring has broken.
Will a solar powered battery charger connected to the cigarette lighter of a Nissan almera equation charge the battery without turning on the ignition?
If the cigarette lighter would normally work without turning on the ignition, yes.
What is the problem when the key won't turn in the ignition to start the car it always starts with the remote starter but it can't be driven without the key activating the starter?
you might try to move your steering wheel at the same time you are turning the key in the ingition. The lock mechanism might be in a bind.
If your starter periodically spins without engaging the flywheel is it possible that your ignition switch may be faulty?
No. The problem lies in the starter itself. Replace the starter and the vehicle will start....
How to reset xtreme remote car starter?
To reset an Xtreme remote car starter, start by turning the ignition key to the "On" position without starting the engine. Press and hold the "Valet" or "Program" button on the remote for about 10 seconds until the LED indicator blinks. Release the button, and then turn the ignition off. This should reset the system, allowing you to reprogram or troubleshoot as needed.
How do you start a car on GTR 2?
I know about the starter and ignition, but I click the ignition and then it clicks, then when I press and hold the starter it starts then immediatly stalls, I have tried it in neutral, in gear, with clutch, without clutch, with clutch and throttle.
When putting in a car battery should your car automatically start?
No, if it starts on its own without you turning the ignition switch then the ignition switch is defective.
What does it mean when you Replace starter and when you go to connect cables to battery the starter starts and stays on without key in ignition until you remove cable from battery?
The wires to the starter are probably connected wrong.
Why would my Tahoe try to start when you connect the battery WITHOUT a key in the ignition?
Did you just put a starter on it ??? Sounds like the starter wires are on the starter wrong are thay are shorted out. CHECK THE WIRES GOING TO THE STARTER CLOSELY.
