A: The diodes are not exactly the same so this unbalance will give an false output.
Ideal op amp approximations: -no current goes into the positive or negative input of the op amp. -The open loop gain is infinite. -Voltage at positive input is the same as the negative input.
The main parameter responsible for virtual ground of an Op-Amp is Input Impedance . Generally , for an Op-Amp it is very high . So , we can conclude that the characteristics of an Op-Amp responsible for virtual ground is high input impedance .
Because op amp consist differential amplifier and they posses high input impedance so that op-amp also posses high input impedance.
why the out put is equal to the positive power supply of the op amp when the nonenverting aom input is greater then invertung input
A basic, single transistor amplifier differs from an op amp: 1. The op amp has more gain 2. The op amp may have higher input resistance (so it loads the circuit less) 3. The op amp may have a lower output resistance (so it can drive larger currents) 4. The op amp likely has a lower frequency response (due to the high gain, unless you provide some sort of feedback loop) 5. The op amp is ridiculously complex compared to a simple amplifier 6. The op amp will require a positive and negative voltage (may be unnecessary with a single transistor amplifier)
It's an op amp (operational amplifier) with a linear response, meaning that double the input means double the output.
I should expect a real-world op-amp to have 5connections:-- the inverting signal input-- the non-inverting signal input-- the signal output-- the power supply input-- the ground connection.
An instrumentation amplifier is made out of 2 or 3 operational amplifiers.
A: They both use transistors. In actuality before an op amp becomes an op amp a discrete transistor made is made to provide it capabilities before it gets integrated into a substrate chip we call op amp. OP AMP have two input to work as a differential amplifier the input are bases closely match to provide virtual no voltage or current offset. Single ended amplifier has one input its reference is the signal source return.
microphone
So long as you remain with the range of the device (power supply rails less a volt or two), the output of an op-amp will go to what ever value is required to maintain the input stages (bridge) to remain the same. So, the effect on input voltage on output of an op-amp is dependent on the feedback circuit.
both are considered to be hi impedance inputs. If a sensor requires a high impedance in order to maintain accuracy, we usually connect that sensor to the positive (+) input terminal of the op-amp.