If inceres the base voltage of transistor them it may be burn . The base volt may be 0.8v to 1.8 If it use as a amplifier
There are none. Germanium transistors are never equivalent to silicon.
The darlington configuration is two transistors connected in such a way that the gain (hFe) of the pair is higher than either transistor taken individually. The two collectors are connected together, and used as the collector of the pair. The base of the first transistor is the base of the pair. The emitter of the first transistor is connected to the base of the second transistor. The emitter of the second transistor is the emitter of the pair. Sometimes there is a resistor between the second base and the second emitter, so as to stabilize the pair in certain conditions. Typically, you multiply hFe's in darlington configuration, so if each transistor had an hFe of, say, 100, then the hFe of the pair would be 10,000.
The transistor
Burns means 'Son Of Byrne'.
7
A silicon transistor is a transistor made of silicon.
The active region of a transistor is when the transistor has sufficient base current to turn the transistor on and for a larger current to flow from emitter to collector. This is the region where the transistor is on and fully operating.
A Unijunction Transistor is a transistor that acts solely as a switch.
Similar to a 2N3906 PNP transistor
how does a transistor behaviour
Power transistor can conduct large amount of currents through it, more than small signal transistor. power transistor has a vertical structure and small signal transistor has horizontal structure.In power transistor quasi saturation region is present which is absent in the small signal transistor. In power transistor there is a inculsion of drift layer which is not there in the small signal transistor. Power dissipation is less in power transistor and it is more in small signal transistor. b.v.polytechnic,vasai pushkar vaity.
I believe that is resistor transistor technology TTL transistor transistor logic
I can give you several sentences.I bought a transistor radio.The transistor amplified the signal.We studied the transistor in science class.
A Darlington pair uses two transistors connected to behave as a single transistor with a very high current gain (beta). Transistor-1 has its collector connected to the collector of transistor-2. Transistor-1 has its emitter connected to the base of transistor-2. The base of transistor-1 with the emitter and collector of transistor-2 is used as a single transistor.
no is not !
the best way is to compeair the data sheet of that transistor to the readings of that transistor. . . . .and u can get the readings of that transistor by using a fungction genrator and a c.r.o
It depends on the transistor, you just have to look at the data sheet for the transistor.