A capacitor and a resistor has no effect on the supply voltage; however, this particular load combination will cause the load current to lead the supply voltage by some angle termed the 'phase angle'.
change in load voltage or output voltage changes in load current
Power factor is the cosine of the phase angle between voltage and current. In a resistive load, current is in phase, i.e. with a phase angle of 0 degrees, with respect to voltage. Cosine (0) is 1.
It changes the tap while it is operation (hence "on load"). This allows real-time voltage regulation for the transformer secondary (as load picks up, causing the voltage to sag, the LTC can tap up, increasing the voltage).
Yes and no. As voltage changes, current changes, causing power to change, with the end result that temperature changes. Most resistors have a small temperature coefficient, so their resistance will change slightly as the voltage changes.
by changing load its terminal voltage changes.
Changes in load.
Changes in load causes the load current to change, resulting in changes in voltage drop along conductors. This means that the 'receiving end' voltage will vary.
A capacitor and a resistor has no effect on the supply voltage; however, this particular load combination will cause the load current to lead the supply voltage by some angle termed the 'phase angle'.
change in load voltage or output voltage changes in load current
The power factor of a load is the cosine of the angle by which the load current lags or leads the supply voltage. So if they are in phase (phase angle is zero), then the power factor must be unity (1).
Voltage and current will be in phase for a purely resistive load. As a load becomes more inductive or capacitive, the phase angle between voltage and current will increase.
Leading angle means that the current lead voltage by 90 degree,which implies a capacitve load. while,lagging angle mean when the current lag the voltage by 90 degree or when the voltage lead the current by 90 degree.which implies an inductive load.
A 'leading' power factor indicates that the load current is leading the supply voltage. Since power factor is the cosine of the angle by which the load current either leads or lags the supply voltage (i.e. the load's phase angle), a cosine of 0 corresponds to a phase angle of 90 degrees. So, a power factor of 0 (leading) indicates that the load current is leading the supply voltage by 90 degrees, which means that the load must be purely capacitive.
Power factor is the cosine of the phase angle between voltage and current. In a resistive load, current is in phase, i.e. with a phase angle of 0 degrees, with respect to voltage. Cosine (0) is 1.
extinction angle control is a scheme of forced commutation for power factor improvement in phase controlled convertors/rectifiers. In this scheme the firing angle is adjusted in order to get the desired output or load voltage. By varying the value of extinction angle we can get the desired load voltage and current waveform.......submitted by abhimanyu(sunny)
It changes the tap while it is operation (hence "on load"). This allows real-time voltage regulation for the transformer secondary (as load picks up, causing the voltage to sag, the LTC can tap up, increasing the voltage).