0
Why will your the keyless remote on a GMC Envoy not work after car battery went dead and after you put new batteries in both the car and the remote?
Wiki User
∙ 15y ago
because the remote is no longer programmed it will need reprogrammed
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you program gm keyless entry remote 1999 gmc envoy?
how do you program keyless entry remote 98 GMC
Your key is stuck in the ignition in your 2003 GMC Envoy is there a key release button?
My envoy did this also when the battery died. installed new battery and key came out.
Which battery does a GMC 04 Envoy use?
group 78--6 year battery
How do you program keyless entry remotes?
This is going to be a quick guide to save you from paying a programming fee for your remote keyless entry for All Yukon and Envoy, Tahoe and Trailblazer models.. This guide will not work for any other models, but will for most all Yukon, Tahoes, and Envoy, Trailblazers including XL and Denali models. If you go to a dealership, you will pay around $50 for programming! This will work on new remotes you just purchased or on old remotes that you may have had batteries replaced that lost program. It must be followed exactly. First, hold down the unlock feature on your door and keep it held down. While holding down, turn ignition key over 2 times and turn off (dont start vehicle). The speed at which you do this is not important, but just turn to where radio will play and instrument panel lights up. After you have done this the unlock-lock will cycle on your doors automatically and the horn will sound. Now, you can let go of the unlock on door and Hold the Lock and Unlock function on the remote, Both at same time! Hold for 15 to 20 seconds until your doors cycle thru lock-unlock. They will do this automatically while you are holding both remote keys. Now, Turn the key over again and then off. This should set your remote to work. If this does not work, there may be a problem with the remote or you may have a remote not compatible with vehicle or even dead battery in remote. Hope this saves someone some time and money! There are some models that can be set up through the (DIC) Driver Information Center. You can go through the options in the DIC until you see where it says to (Learn New Remote) or something to that nature. When you push the check mark and hold it down it will say learning new remote. You then hold the unlock and lock buttons on your remote keyless entry. This may take a few seconds, but should take care of the programming process. This really works! I just used it to program my 2005 Tahoe LT keyless entry system!
How do you program a key remote for a 2005 GMC Envoy?
The procedue is documented in the ownwer's manual.
You just replace the battery on 2002 gmc envoy XL?
Yes.
What size battery for 1.7 envoy astra diesel van?
70amp
Why does your 2001 Envoy needles bounce but wont start?
Weak battery
Como programar un control remote de una 2004 gmc envoy?
Check
How can you reset airbag light on 2003 GMC ENVOY?
The airbag light in the 2003 GMC ENVOY can be reset by disconnecting the battery for about 5 minutes. Then reconnect the battery, turn the key to on without starting the vehicle, and pump the gas pedal three times if the light is still on after reconnecting the battery.
Can a bad 2002 GMC envoy Oxygen Sensor drain the battery?
No, it can cause you to use and excesive amount of fuel but it will not effect the battery.
Why doesn't My 2002 envoy's instrument cluster work?
If the instrument cluster on a 2002 Envoy is not working, check the fuses. There is a main fuse for this under the hood on top of the battery.
