0
Why won't 1986 Ford Ranger 2.9 L V6 4x4 start or even crank when all accessories come on when the key is on but no starting noises?
Wiki User
∙ 14y ago
You mite have a ground some where that is not making full contact. It could either be from the motor to the body or frame to the body.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Were is the crank shift sensor at on a 94 ford ranger 4.0?
Where is the crank sensor located on a 94 ranger 4.0 motor
Crank sensor 4.0 1993 Ford Ranger?
Next to the crank pulley. Held on with 2 10mm bolts.
No power to fuse box engine will not crank and no accessories but the battery has juice?
Check the cable.
How are BHP and horsepower differentiated?
HP is from the crankshaft with... BHP is from crank with no accessories just raw power
To find the ingition relay?
my ranger will not crank unless the clutch is pushin. could it be a relay
How do you change a timing belt for a 99 ford ranger?
you just do what mark on the crank is TDC
92 ford ranger has no spark new module crank sensor?
its junk! crush it!
Is there any adjustment to a crank shaft position sensor on a 1996 ford ranger 2.3 liter?
no
Does a crank sensor have anything with starting on a 96 Chevy vortec?
if the crank sensor is bad it does not tell the computer that the crank is turning it will not fire up the engine.
Will a crank sensor keep the car from starting?
Yes it could
Will a dirt bike crank when its low on gas?
yes it will crank, because cranking of the engine depends on the starting motor,it has nothing to do with fuel.But remember it will just crank not run.
On a 1994 ford ranger the crank position sensor it brakes the magnet off the sensor and there is not enough adjustment to stop it how can you stop that?
On a 4.0 V-6 the crank position sensor is in a fixed location and cannot come in contact with the crank if it is installed correctly.
