Check for spark at the plugs, if good, then check for fuel. Also check the fuel shut off in the trunk. The breaker might have tripped.
2002 ford crown Victoria how to repair crank sensor?
Same as my 2002 P71. Battery had short. Replaced battery - worked perfect!
which one the power steering,alternator,crank or a/c,crank?
when my camshaft sensor was going bad, the vehicle refused to crank after being driven and parked for a few minutes. If you wait a little while it may crank. I heard of people pouring water on the sensor casing to crank them also.
check your spark plugs
ur battery or starter needs to be replaced
crank sensor
cheap back up to crank sensor. it may allow the car to run with out crank sensor, though poorly
Fuel, or spark. Also could be something else, but start at the beginning.
just give it a positive 12v before the starter and after it it will crank after and before if it works
The crank shaft sensor is located on the bottom portion of the timing cover to the left of the crank pulley. Look for two wire harnesses and remove them along with the bolt.
Yes. I had this problem on a 2000 Grand Cherokee. The problem came without any warning that I could notice. I parked it at night and the next morning it would crank and crank but not start. - I would imagine that his problem could happen gradually if the sensor had a broken lead wire or was gradually failing. In my case it was immediate and complete failure.