0
What else can I help you with?
Steering wheel hard to turn in 1994 Lexus ls400?
1991 Lexus ls400 hard steering at ilde rack &pump have been replace all screencleaned or removed.
How do you charge the air conditioning on a 1990 Lexus ls400?
connect an ac gauge and freon to the low side ac port. Start the engine and turn ac on high. Open the freon and watch til the gauge shows full.
What are the symptoms of a bad ignition switch on a 1992 Lexus ls400?
Symptoms of a bad ignition switch on a 1992 Lexus LS400 may include difficulty starting the vehicle, intermittent loss of power to the dashboard and accessories, and the engine stalling unexpectedly. You might also notice that the key feels loose or doesn't turn smoothly in the ignition. Additionally, electrical components may behave erratically, such as the radio or lights flickering. If these issues occur, it's advisable to have the ignition switch inspected or replaced.
Why will a Lexus rx300 only turn over when you press accelerator then immediately die?
Check for low fuel pressure.
How to reset timing on Lexus LS400 with two distributors?
The timing is set by aligning the timing marks on the camshaft pulleys with the crankshaft pulley. The easiest way is to use the markings on the timing belt. Then turn the engine by hand through 2 revolutions to make sure the timing marks line up.
Lexus LS400 brake light How do you replace?
You can access the brake light bald through the trunk compartment. Remove the trunk liner from the tail light assembly. Push the brake light connector in and turn at the same time. The brake lightbulb will come out. Reverse the process to install the new brake light
Why would a 1991 Ford Ranger with a good battery not turn over?
Bad Starter....
1991 Pontiac 6000LE won't start?
Does it turn over? Does it have: fuel spark compression?
Cancel timing belt light on Lexus lx470?
probably have to have a Lexus dealer turn it off
How do you self diagnostic a 94 ls400?
To perform a self-diagnostic on a 1994 Lexus LS400, locate the Diagnostic Test Mode (DTM) connector, typically found under the driver's side dashboard. Use a jumper wire to connect terminals TE1 and E1 in the connector. Turn the ignition to the "ON" position without starting the engine, and observe the check engine light, which will blink a series of codes indicating any issues. Refer to the vehicle's service manual for specific codes and their meanings.
Reset a navigation system on Lexus gs300?
I am not able to turn on the volume on gps in my lexus gs300 navigation
Why won't my 1991 gmc k1500 truck not turn over?
why would you want to turn it over? you can use jacks, a light and a creeper to look at the bottom, less expensive too!
