I am having the problem of it runing out of fuel I found pin holes in the rubber tubin at the Valve selector switch check all rubber hoses
Also after that repair i could dive it for about 20 miles it started runing out of gas again found the Cam lob worn replace the cam
There is a c-clipthat holds the crank in place,you just need to push it off and the crank comes off.
Check the ignition control module.
the seal on the crank shaft needs replaced
where is the crank sensor located on a 2005 chevy impala
my 95 s-10 will not crank i ck the starter , bat they are good the willing to the starter is good ,i replaced the ingnition switch,the key switch whats left Scott from Ohio
Chevy did not use a crank sensor on that year.
trying to locate crank shaft sencor for 1993 Chevy lumna trying to locate crank shaft sencor for 1993 Chevy lumna
a Chevy 350 crank is a Chevy 305 crank. they have the same stroke, 3.48 inches, and are interchangable. swapping between the two cranks does not change the engines displacement
You need to clear the codes with a engine scanner.
tighten the nut from the starter to the solenoid
Just the crank. The flywheel is neutral.
No.