answersLogoWhite

0


Best Answer

It is most likely a clutch problem, assuming this is a manual transmission. If you are lucky, it is a leaky clutch slave cylinder and you can top up the fluid in the reservoir (usually located near the back of the engine on the firewall and smaller than the brake master cylinder reservoir). Probably uses brake fluid but check your owner's manual. If you are unlucky you need a new slave cylinder or clutch or both. If you are really unlucky, the transmission is shot.

User Avatar

Wiki User

18y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why won't your 1991 ford probe go into any gear when it has not shown any signs of a problem?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is idler sensor on 1991 Ford Probe?

The Throttle body is where all the sensors are for this car. If your having an Idle problem though, It is rarely that.


What type of automatic transmission fluid does 1991 ford probe require?

what type transmission fluid uses for a 1991 ford probe


Will a 1991 Mitsubishi eclipse body parts fit a 1991 ford probe?

will a 91 Mitsubishi eclipse body parts fit a 91 ford probe


Where is the horn on a 1991 Ford Probe?

It is in front of the radiator.


Where is Transmission fluid intake reservoir on 1991 Ford Probe P?

The 1991 Ford Probe does not have a transmission fluid intake reservoir. All of the transmission fluid is contained in the transmission.


How many quarts of oil for a 1991 Ford Probe?

four


Why would a 1991 Ford Probe turn off numerous times while driving but restart with no problem?

Ford Probe's are known for water getting in the distributor cap. If it happens on a day that when its wet outside check your distributor cap to see if theres any water in it.


Where is the dura spark ignition module located on a 1991 Ford probe?

The 1991 Ford Probe spark ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.


Where is the sensor for the engine coolant on a 1991 Ford Probe lx?

The sensor for the engine coolant on a 1991 Ford Probe LX is inside of the coolant tank. There is a lever, and when the fluid gets below this lever, it signals to be checked. It should be refilled.


Is a 1996 Ford Probe 5 Speed transmission interchangeable with a 1991 Ford probe 5 Speed?

no but if you can find an 88 to 92 tranny it will work fine


How many quarts of fluid does a 1991 ford probe manual transmission hold?

3.9


When did Time Signs end?

Time Signs ended on 1991-07-21.