0
What else can I help you with?
How do you find and change the thermostat on a 1997 Ford Probe GT?
try this link it may help keep in mind ford probe's have Mazda engine's
What does engine code 173 on 1991 Ford Bronco mean?
Code 173 indicates the oxygen sensor is telling the computer that the engine is running rich.
Where is a obd 1 plug located on a 1991 ford probe?
The DLC (Diagnostic Link Connector) should be located in the engine compartment on top of an inner fender close to a relay/fuse center. It may be snapped into a protective cover.
What is the sensor located on the rear of your Ford Rangers 3.0L Duratec engine?
crank sensor
Your 1991 Ford Festiva wont start i changed the spark plugs and tried spraying it with starter fluid but it will only run for a few seconds why?
1st check your air flow sensor, then the fuel pump.
Where is the sensor for the engine coolant on a 1991 Ford Probe lx?
The sensor for the engine coolant on a 1991 Ford Probe LX is inside of the coolant tank. There is a lever, and when the fluid gets below this lever, it signals to be checked. It should be refilled.
Where is the crankshaft position sensor on a 96 Ford Probe SE?
"Where is the crankshaft position sensor on a 96 ford probe SE?"
What type of automatic transmission fluid does 1991 ford probe require?
what type transmission fluid uses for a 1991 ford probe
Will a 1991 Mitsubishi eclipse body parts fit a 1991 ford probe?
will a 91 Mitsubishi eclipse body parts fit a 91 ford probe
Where is the horn on a 1991 Ford Probe?
It is in front of the radiator.
Where is Transmission fluid intake reservoir on 1991 Ford Probe P?
The 1991 Ford Probe does not have a transmission fluid intake reservoir. All of the transmission fluid is contained in the transmission.
How many quarts of oil for a 1991 Ford Probe?
four
If both the idler air sensor and the oxygen sensor shows malfunctioning which should be replaced first on a ford contour 95?
First, change the oxygen sensor and the air filter. Clear the codes and see if the idler air sensor code comes back.
Where is the dura spark ignition module located on a 1991 Ford probe?
The 1991 Ford Probe spark ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
Where is your cam sensor on your Ford Probe gt?
the camshaft sensor is located in the distributor. you need to purchase the entire distibutor to replace the sensor.
Is a 1996 Ford Probe 5 Speed transmission interchangeable with a 1991 Ford probe 5 Speed?
no but if you can find an 88 to 92 tranny it will work fine
Where is the crank shaft positioning sensor located on a 94 ford probe?
2.0ltr its in distributer
