answersLogoWhite

0

Why won't my 1990 300zx rev past 3500?

Updated: 8/16/2019
User Avatar

Wiki User

14y ago

Best Answer

Replace the mass air flow meter(s) (MAF).

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why won't my 1990 300zx rev past 3500?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

1988 300zx wont start but security system?

fddd


Your Nissan 1991 Nissan 300zx twin turbo wont start?

no power to starter on Nissan 300zx twin turbo


Why wont my 84 300zx stay on?

prob your fuel pump relay


Your 1990 automatic 300zx wont shift gears automatically you have to let off the gas for a second to get it to shift is there a sensor bad or is it the tranny?

I had the same problem. I found that my 2nd and 4th gears were worn to the point of non existance.


1990 Nissan 300zx starter turns over but car wont start What could be some possible causes?

the teeth on the starter could be worn out or the teeth on the flywheel could be worn out ... hopefully for you its just the starter if its the flywheel you will have to pull the tranny ...


Why wont my 1990 Acura Integra pass 3500 rpms?

well i had that problem with my integra, all i did was change the ecu to a single cam si ecu (PM6) or another ls ecu (Pr4) that should fix the problem


Your Nissan 300zx ac wont blow out no air no heat and no air will come out?

Have you checked the 30 Amp fuse ?


Astra 1.7cdti wont rev past 3000rpm?

Astra 1.7 cdti wont rev past 300 rpm


When You put your Key in the ignition of a 1984 Nissan 300zx and it wont turn at all what do you do if its a manual transmission?

try wiggling the steering wheel it has a lock on it


Your 1985 Nissan 300zx turns over but wont start?

air flow is bad or t.p.s is bad check spark, check fuel


93 300zx starts but wont stay running?

check you ecu under the kick plat on the pasanger side then you might have to change you ptu


Why wont your 91 300zx go above 2500 rpm?

run ecu codes, your Mass Air Flow Sensor is probablly bad or dirty