0
Why won't the backup lights on 93 Ford Probe work but the turning signal and brake lights do?
Wiki User
∙ 17y ago
The backup lights are a different bulb, then the turn signals and brake lights and The Number 1 reason would be that the bulbs are burned out and need replaced. Good Luck and Remember.
Change Your Mind, Not Your Oil.
Use the First In Synthetic Motor Oil's.
See My Bio For Information & Contact Details.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
How do you simulate a pH probe output signal?
Try a transmation unit, I would assume that the pH probe puts out either a 0 - 10 Vdc, 4 - 20mA signal. Set the Xmation unit to the similar and connect its output where the pH probe is sending its signal.
How do you raise and lower the headlights of a 1993 Ford Probe?
Answer: on the turning signal switch turn the handle forward for headlights. high beams pull in to flash. push out for high beams to stay on.
What is use of logic probe in electronic?
we use logic probe in circuit because logic probe is use to indicate where signal is high or low on ic chip.
Where are tail lights on Ford Probe?
Check the back of the car.
How do you adjust the headlights on a 1997 Ford Probe GT?
there are four screws behind the covers on the probe head lights put the car up to a building on a flat serface and adjust the lights to whare u wont them.
How can distance speed time and motion measured in space?
The speed of something orbiting another body can be calculated from the mean altitude of the orbit and the mean radius and the mass of the body. The distance to an interplanetary probe can be calculated from the time elapsed from the sending of a communication signal to the probe until receipt of acknowledgement of the signal from the probe. The speed of the probe can be calculated by doing that twice. The rate at which time passes for an object in space can be calculated from the speed of the object.
Dome light and floor board lights in 94 ford probe won't go off?
The dome light and floor lights on a 94 Ford Probe will not go off if the door is open or the door sensor has not been tripped. The lights can be manually turned off but the sensor should be checked for defects.
How do you wire the fog-lights on a 1993 ford probe gt to come on with the park lights?
Go to www.the12volt.com They have an excellent schematic on how you do it with a couple of stadard relays.
Code 55 for Ford Probe 1990?
Code 55= "No input signal from vehicle speed pulse generator"
What is the 10 missions?
Pioneer 10 was a deep-space probe operated by NASA. It was launched on March 2, 1972. The probe had too little power to signal back and is now lost. As of February 8, 2012 the probe is 105.197 AU, far outside of Pluto's orbit.
Can you use a fog light switch from a prob gt for aftermarket fog lights on a probe base model?
Yes you can.
How do you pile photon cannons on top of each other in Starcraft?
Hot key a probe (control, 1) then if there is a light switch turn the lights off. There has to be a light switch for stacking. After the lights are off press 1. This will select your probe. Then you can make cannons and other buildings on top of each other.
