answersLogoWhite

0


Best Answer

The dome light and floor lights on a 94 Ford Probe will not go off if the door is open or the door sensor has not been tripped. The lights can be manually turned off but the sensor should be checked for defects.

User Avatar

Wiki User

9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Dome light and floor board lights in 94 ford probe won't go off?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can you use a fog light switch from a prob gt for aftermarket fog lights on a probe base model?

Yes you can.


How do you pile photon cannons on top of each other in Starcraft?

Hot key a probe (control, 1) then if there is a light switch turn the lights off. There has to be a light switch for stacking. After the lights are off press 1. This will select your probe. Then you can make cannons and other buildings on top of each other.


Where is the fuel shutoff switch in a 4cylinder 91 ford probe or does it have something else?

In the trunk to the far left side under the floor board.


How do you connect daytime running lights for 2004 Honda Element?

First you must be able to use a test light. .. Remove the clam shell that encloses the steering column. Then with the key off and removed find the bundle of wires that go to the light switch. Turn on the head lights and probe the wires one by one till you find one that lights up. STAY AWAY FROM THE YELLOW WIRE BUNDLE THIS IS THE AIR BAG YOU WILL DIE. With the light probe lit turn off the headlights and if the probe goes out you have found the running light wire , try again till the wire goes out as the headlights do. First you must be able to use a test light. .. Remove the clam shell that encloses the steering column. Then with the key off and removed find the bundle of wires that go to the light switch. Turn on the head lights and probe the wires one by one till you find one that lights up. STAY AWAY FROM THE YELLOW WIRE BUNDLE THIS IS THE AIR BAG YOU WILL DIE. With the light probe lit turn off the headlights and if the probe goes out you have found the running light wire , try again till the wire goes out as the headlights do.


Does voyager 2 carry a space probe on board?

Voyager 2 is a space probe.


Security light stays on in a 93 z28?

If the security light stays on in a 1993 Z28, there could be a problem with the settings for the lights. Sometimes the adjustment knob for the interior lights gets bumped. There is also a possibility that the probe that is in the door hinge area has been broken off.


If the fuses and bulbs are okay what is wrong if the tail lights and dash light do not work on a 1990 Ford Probe GT?

Corroded or loose terminal. Bad ground.


Where are tail lights on Ford Probe?

Check the back of the car.


Are aftermarket tail lights available for the Ford Probe?

If your looking for a replacement then either go to a scrap yard or check our SEL-IMPERIAL. Or if you are looking for a modded version check out the American Ebay site. I've looked everywhere and everone tells me that nobody makes an aftermarket tail light for the probe. Look it up on different sites, you'll see that there isn't even a section for the probe under tail lights.


Where are all the brake light grounds on 1990 sundance when the headlights are off then brake lights are fine but when u turn headlights on then the brake lights don't work except the cyclops lights.?

You probably have a loose wire connection in the brake light sockets. Insert a nail or probe tip into the back of the light socket where the wires are inserted and test the brake lights. (The socket can appear perfectly normal and the wires may even seem well attached.)


How do you replace the left pop-up headlight on a 1997 Ford Probe GT?

Open the lights, unscrew the bezel cover, then unscrew the light. It will pull out and you can disconnect the wires easily. Just reverse this method to put the new light in Most of these lights at Wal-Mart are $10-15 and simple to fix.


How do you adjust the headlights on a 1997 Ford Probe GT?

there are four screws behind the covers on the probe head lights put the car up to a building on a flat serface and adjust the lights to whare u wont them.