Check the ignition coil on the Cheyenne. If it is ok, check the timing. The timing chain could have slipped or broken causing the engine to not start.
i just had a similar problem well after changing fuel filter,plugs,wires,pcv valve map sensor(all was not the problem)i found it to be the crankshaft position sensor,changed it and the car runs like new hope this helps
They showed how mathematics and measurement could be used in scientific investigation. (~PSPLieKur)
Have an electrician check the wiring that goes to the brake lights in the trunk of the car.
If the battery and alternator are both good, Test them to be sure, then you need to take a multimeter and verify that the power from the alternator is actually reaching the battery. It could be a simple wiring problem
Problem in the emission system - have vehicle scanned to determine problem
It changed it because, they could look deeper into what they were looking for.
This could possibly be a fuel problem. Has the fuel filter been changed ? Fuel pressure checked ? Is there dirt in the fuel tank ?
I don't know about the Explorer but I had an experience with a Ford Mustang. I changed about everything I could think of related to the non-starting problem. Then I discovered there was a filter in the gas tank. Changed it and the problem disappeared!
A person born in Cheyenne in the US could be from the state of Wyoming (Cheyenne is the state capital), Oklahoma, Texas, or Kansas.
Change the wire, or coil plug
Panic is when you freak out and don't know what to do. You get so nervous or angry or scared that you are only thinking about that and not thinking about what you could do to resolve a problem. Terror is when you are extremely scared.
Had same problem and changed the ignitionmodule, problem solved and runs great
I would have your alternator checked as I had a similar problem and changed mine. Worked fine after that.
In Cheyenne you could either say tsehe-meshemestovestse, which also means father-in-law, or na-mesheme (my grandfather)
try the moduel
changed battery engine light stays on
well the motor will be sluggish. i had the same problem i changed all 3 for less than a $100 and i also changed the plug wires as well. your problem could be the wires . but for $130 to $150 change both.