Problem in the emission system - have vehicle scanned to determine problem
check the engine block casting number
No, the check engine light does not come on because your gas is half way full. The check engine light will come on if there is a problem with the engine.
no a burnt out headlight will not cause a check engine light but if you go to most of the part places they will check the check engine light for free
Check the ignition coil on the Cheyenne. If it is ok, check the timing. The timing chain could have slipped or broken causing the engine to not start.
in the trunk if you see the numbers in the trunk sticker that's says 9c1 then its not an impala if it says wx3 its a real ss im not sure if the doors have those numbers but its always good to check the doors as well
It requires a scanner to properly diagnosis a check engine light.
well, check your oil, engine coolant, and your radiator.
A lot of parts stores will check it for free
Check engine is an error. You have to go at a garage to see what is the error code, then correct the problem.
check the engine block casting number
The check engine light will illuminate.
I am sorry but you do not without the proper equipment.
Transmission jumping hard is the malfunction causing check engine light to come on,most likely its the tcc solonoid causing this or a possibility of causing this.
your engine might be overheated, causing the vibrations
You need to connect a OBD-II Scanner to find out.....
To reset the Check Engine Light you must go to the trunk of your car get a cro-bar and smash the dash board until the light doesn't come on no more...
To reset the Check Engine Light you must go to the trunk of your car get a cro-bar and smash the dash board until the light doesn't come on no more...