answersLogoWhite

0

Worn out main and cam bearings, tired oil pump, restricted oil sump screen.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

I Changed oil pump but still no oil to top of motor on 98 grand am with a 3.1?

When the oil pump was changed, was the pickup tube cleaned also? Could that be plugged?


Where is the oil pressure switch on a Subaru Outback?

Top front of engine, beside Oil Pump, right above Oil Filter.


What happens when oil drop falls in milk?

it will float to the top, but the milk wont be safe to drink anymore depending on what kind of oil it was


Where is the oil pressure switch on a 1996 Subaru Outback?

Top front of engine, beside Oil Pump, right above Oil Filter.


What would cause No oil getting to top of engine?

the oil pump in the oil pan is bad, or worn bad enough that it no longer can push enough oil


Where is the high pressure oil pump on a 7.3L powerstroke?

top front center of engine


Where is located the oil pump in an Oldsmobile bravada?

In an Oldsmobile Bravada, the oil pump is typically located inside the oil pan, which is situated at the bottom of the engine. To access the oil pump, you usually need to remove the oil pan, as it is not directly accessible from the top of the engine. The oil pump is driven by the engine's crankshaft and is responsible for circulating oil throughout the engine for lubrication. Always refer to the specific service manual for detailed instructions and safety precautions.


Where is the high pressure oil pump on a 2002 7.3L powerstroke?

it is the front top center of engine


Does a failed oil pump ruin the engine?

Hi Yes I'm afraid it does. The oil pump is usually in the sump, oil is pumped up to the top of the engine and lubricates the valve rods the piston rings and the big end bearings.


How do you replace the oil pump on a vauxhall Corsa 1.7CDTi?

take the old one off. then put the new one on and top up with oil


How do you drain a Yamaha zuma's 2 cycle oil?

with a pump and siphon tube out the filler cap. Unless you're dead set on getting every last drop, in which case you have to remove the air shroud on the right side of the cylinder to expose the oil pump, and remove the oil supply tube from the top of the pump to drain the tank. Be careful to keep the inlet of the pump filled with oil, or you'll have to bleed the pump.


Where is the oil pressure sending unit on a 1979 trans am with olds 403?

Near top of water pump