i would say because it is not getting spark but i have a 77 cutlass with the same problem so check it for spark
I have a 92 cutlass ciera doing that, would run til it got hot, then die...ended up being the crank shaft sensor. hope this helps
the crank sensor is behind the harmonic balancer
Nee more info cutlass supreme or cutlass ceira which engine 3.1-- 3.8-- 3.3-- ????? Oldsmobile cutlass ceira 3.3 liteer engine
Behind the harmonic balancer (dampner) that is located behind the crankshaft pulley.
On a 1991 Oldsmobile Cutlass Calais with a 2.5-liter engine, the crankshaft position sensor is typically located near the bottom of the engine, often mounted on the engine block or transmission bell housing. It is positioned close to the crankshaft to accurately monitor its position. You may need to access it from underneath the vehicle for better visibility and reach.
The 1991 Cutlass Cierra came standard with a 4 cylinder engine. This would require 4 spark plugs to tune up the engine.
check crank sensor
Follow the pos battery cable and it is at the engine end.
The horn relay on a 1991 Oldsmobile Cutlass Cierra is located on the passenger side firewall inside the engine compartment. It is just to the left of the blower motor assembly.
If you still need to know the crank sensor is located on the front side of the engine mounted just behind the harmonic balancer. That would mean the side of the engine with the belts and behind the big pulley at the bottom of the engine. Hope that helps.
no it does not... only the 1.6 has one
That depends on which engine you have, which you failed to mention. Go to the link below and pick the correct engine.