0
What else can I help you with?
How long does a 4x400m run take in track?
well normally it takes 44 seconds on an average for 1 of them to do it. So it would be: 44x4=176 seconds=3 minutes and 33 seconds (aprox)
How much power is used when Joules of work are done in 10 seconds?
Power is calculated by dividing the work done in Joules by the time taken in seconds. So, if x Joules of work are done in 10 seconds, the power used would be x/10 watts.
Contingent strategies would not normally be associated with a workstation?
uninterruptible power supply
If a car can go 0 to 60 mph in 8 seconds what would be its final speed after 5 seconds if its starting speed were 50 mph?
87.5mi/hr2
Your iPod will not come on why not?
Try plugging the iPod into your computer as you would normally charge it. If this does not work, hold the Home button and the Sleep/Wake (power) button simultaneously for 6 seconds, and then see if it turns on. If it does not come on, something might have shorted the iPod's circuitry.
How much power would a person use to move the same piano in 5 seconds?
The power needed would depend on the force required to move the piano and the distance it is moved in 5 seconds. Without knowing these factors, an accurate estimate cannot be provided.
How much power is used when 600 joules of work are done in ten seconds?
The power used would be 60 watts. This can be calculated by dividing the work done (600 joules) by the time taken (10 seconds).
Why would your car lose power after starting and shut down?
its faulty
What is a nc contact?
An N.C. contact is 'Normally closed'. This applies to relays (electronic switches). You can use either a normally closedcontact or a normally open contact to do what you need, provided the relay has both and depending on your situation. Here's a recent example of mine: A building's fire alarm is wired to the HVAC system to shut down ventilation in case of a fire. In this case we want the HVAC to have power normally but remove power (with the relay) during a fire alarm. We would connect the HVAC power to the relay's N.C. (normally closed) contacts, because they are exactly that: normally closed. This would allow the HVAC to function. When power is applied to the relay, it would switch contacts, disconnecting power to the HVAC. An important note is that contacts and other electrical connections that can change condition (such as a relay) are described in a de-energizedstate. Thus, the N.C. contacts are normally closed, while the power to the relay is off. Likewise, a N.O. contact is open with relay de-energized but will close upon supplying power to the relay.
What would cause the check engine light to remain on in a 2005 grand am before you start the ignition?
The light should be on before starting, and for 3 seconds after starting, as a bulb check.
How does Arceus change types?
You have to give it the plates you find. He changes to the type that it would normally boost the power of.
How long before service would be back on if power goes off?
Depends on what caused the power to go off, could be seconds or it could be days.
