0
Why would a car not have any power unless connected to jumper cables then once connected still not turn over?
Wiki User
∙ 12y ago
Sounds like you need a new battery that works.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you close your trunk if the battery is dead on a 95 sedan deville?
connect another cars battery with jumper cables. Will power the trunk motor, and allow it to be closed once cables are connected ( PROPERLY ). You might even be able to jump start car. Good luck
What happens if you try to jump a fully charged battery?
Jumping a Fully Charged BatteryIF the connections [jumper cables] are connected properly, then nothing out of the ordinary happens. Connecting a jumper battery or power axillary power source only makes additional current available, if the starting circuit needs it. If the batteries are connected properly [in parallel] then this procedure increases the cranking Amps available and the voltage remains the same.
How do you remove a battery from a 2001 Passat 1800TI?
Best and easiest way to change battery in any Volkswagen. Remember if your computer loses power it will go into limp mode and you will find yourself at the dealership for vag-com. Have a friend with a good battery and a set up jumper cables and hook cables from his battery to yours, loosen battery terminals on your battery and carefully remove battery with out knocking the cables off (remember keep power to the battery cables on your WW). Carefully install your new battery and tighten the terminals. With jumper cables still hooked to your car start your engine, then remove the jumper cables. I would then take car for a short drive to ensure that there is a full charge to the battery you just installed.
How can you tell if a jumper is on or off?
A jumper is closed (on) if the cover is in place, connecting the two pins that make up the jumper; a jumper is open (off) if the cover is not in place.
How many wires connected to the CD rom?
Usually two cables total. Such as the SATA Cable and the power cable. As for how many wires are in those cables, it would depends on the connection. Such as IDE have 40 wires. Power cables are usually four pin. It all depends.
How to fix Acura power window cables?
Acura power window diagrams are the best way to see how the cables are connected. Auto repair books show and instruct step by step how to repair problems a vehicle may have.
How do you upgrading hdd?
Connect new hdd and check for proper jumper connection. Configure both HDD to master and slave if they are connected using same IDE cable or if they both have different set of IDE cables, then just connect the HDD and provide power cable from SMPS.. Similar for SATA HDD
How do you open the boot on a BMW 840 with dead battery and no key?
You can then open the hood and provide power to the vehicle with jumper cables and a donor car. If all else fails you can jack the vehicle up, support it on a jack-stand, and attach a red jumper cable to the starter positive red cable where it connects to the starter and then attach black cable to any metal place on the engine. You can use this procedure to charge the battery with either a battery charger for jumper cables from a donor vehicle.
What is the purpose for the SATA-style power connector?
SATA power connector is a type of power cable with which we can provide Disks power from the mother board. SATA Power cables are connected from sata point on motherboard to the drive.
How do you open the trunk on a 525i 2004 BMW with no battery?
You can unlock the doors manually if you turn the key far enough. You can then open the hood and provide power to the vehicle with jumper cables and a donor car. If all else fails you can jack the vehicle up, support it on a jack-stand, and attach a red jumper cable to the starter positive red cable where it connects to the starter and then attach black cable to any metal place on the engine. You can use this procedure to charge the battery with either a battery charger for jumper cables from a donor vehicle.
How do you get into the boot of a BMW 840 with a dead battery?
You can unlock the doors manually if you turn the key far enough. You can then open the hood and provide power to the vehicle with jumper cables and a donor car. If all else fails you can jack the vehicle up, support it on a jack-stand, and attach a red jumper cable to the starter positive red cable where it connects to the starter and then attach black cable to any metal place on the engine. You can use this procedure to charge the battery with either a battery charger for jumper cables from a donor vehicle.
How do you open your BMW 525i when the battery is dead?
You can unlock the doors manually if you turn the key far enough. You can then open the hood and provide power to the vehicle with jumper cables and a donor car. If all else fails you can jack the vehicle up, support it on a jack-stand, and attach a red jumper cable to the starter positive red cable where it connects to the starter and then attach black cable to any metal place on the engine. You can use this procedure to charge the battery with either a battery charger for jumper cables from a donor vehicle.
