A factory radio will go off when you use a turn signal because of a bad connection, and you are advised to check the antenna lead, grounds, and the flasher.
Ma key wont turn over because i took the factory radio
Why would you want the blinker faster. They should blink at factory specs.
Behind the radio
Above the radio there is a button with red triangles on it. That is where the turn signal flasher is. You have to take the dash off to get to it.
if someone is playing there radio veryloudly, and have been asked repeatedly to turn it down, but refuse. is there any way to block the received radio signal.
You don't actually get it. When you get the Kanto radio card you turn on the radio and move the signal to the top middle.
My turn signal stop working know my car will not start if the turn signal is up or down
Check for a loose fuse, check your wiring, check the connections, sounds like something is loose. Also make note as to when it turn off, are pressing the brake? using the turn signal? I had a firebird that every time I press the brake the signal lights would turn on and the radio would turned off, that turned out to be I used the wrong bulb in my brake lights
In this type system a RADIO FREQUENCY signal (RF) is sent over the normal building power wiring. (not through the air) There would be a transmitter to send the signal and a receiver to receive the signal. This signal would contain data to report or instruct. A common application would be to turn lights on and off remotely.
the signal flasher is the hazard light switch......remove the radio bezel and change the switch
rmove the radio and it is directly behind it.
== == It's in the AC vent above the radio