The intake manifold basket was a bad design that was replaced with a better design. Sometimes when this basket leaks, it can get the sensor wet and cause it to corrode. Replace the sensor and manifold
Where would the knock sensor be located on a 2004 mazda 6?
If just the knock sensor need to be replaced. I would say no more than $150.00
I have a 240 and with the knock sensor unplugged it will still start so I would have to say no.
No. It only senses engine vibration/knock.
A knock sensor is located in a specific area on the block or cylinder head in order to sense spark knock occuring and send a signal to the ECM to retard the timing. Relocating the knock sensor would defeat its purpose.
If a knock sensor was bad, the check engine light would be illuminated and the code(s) set would indicate so.
No it will not.
The function of the knock sensor ob a sensor on a 1991 4.3 s10 is to provide the computer the position of the crank shaft to give it the right information to get correct timing. That would be the crank position sensor. The knock sensor monitors the engine for spark knock (ping) so the ECM (Engine Control Module) can retard the timing to eliminate it.
just curios as to where a knock sensor would b located on a 95 vw golf gti 2.0
A bad knock sensor would illuminate the check engine light and allow the engine to ping (spark knock). The engine doesn't shift, the transmission shifts.
it shouldnt.
There are no symptoms since the knock sensor doesn't do anything unless the engine is detonating, in which case it would do nothing and you would hear it. The knock sensor code is often tripped when there is a fault in something else since it's part of the same circuit. This is considered a "ghost" error code.