0
What else can I help you with?
Why does the parking brake pedal go to the floor on a 97 suburban?
probably have broken parking brake cable.
How do you replace the brake light switch on a 1996 suburban?
Look under the dash on the 1996 suburban, and locate the brake light switch on the brake pedal arm. Remove the switch nut, and slide the switch out. Unplug the wires from the switch and install the new switch.
Why would brake lights not work on 1996 Chevrolet Suburban after fuse and light bulb been check?
Recommend checking the operation of the switch that is actuated by the brake pedal itself. This switch is either mounted to the brake pedal or mounted under the dash and actuated by the movement of the pedal
1997 mercury villager what causes the brake pedal to go to the floor when there is no ABS light?
A brake pedal going directly to the floor is a sign of a few things. First, you are in need of brake fluid. Second, the brake pads are probably almost worn out. They may be worn out past the point the ABS light would be active. The ABS light may also be burned out.
How do you remove the brake pedal on 98 suburban?
To remove the brake pedal on a 1998 Suburban, unscrew the bolt that holds it to the steering wheel column. There are several wires that also have to be disconnected from here that control brake lights.
Why do the brake lights on a 1992 Mustang only come on when the brake pedal is pushed all the way to the floor?
The brake light switch is out of alligment. Check on the brake pedal arm and readjust the switch.
Where is the brake light switch on the 1999 Chevy Suburban?
follow the brake pedal to the house, and you will see the harness behind that. follow that harness and it will lead to a second plug that you can access on work on
Why do brake lights only work occasionally on a 1994 GM Suburban 1500 if the taillights work?
The brake light switch may be bad or out of adjustment. The switch is located just above the brake pedal.
Why do brakes lights on 2003 Suburban come on by themselves after car has been shut off for hours?
You must have a faulty brake light switch...it connects to the brake pedal...if you look up to the top of your brake pedal, you will see a little "box" with a button that is released when the pedal is pushed down. They are cheap and easy to replace.
What are symptoms of a bad brake master cylinder on 94 Suburban?
The most common way to test this is,at a stop with your foot on the brake, the pedal will very slowly go to the floor, there is a test for this but you need to be good at auto repair.
Where is the emergency brake release on 2008 suburban?
On a 2008 Chevrolet Suburban, the emergency brake release is typically located near the driver's side, either on the floor next to the driver's seat or as a lever on the dashboard. If it's a floor-mounted release, you will find a lever or pedal that you can pull or press to disengage the brake. Always check your owner’s manual for specific details related to your vehicle's configuration.
No brake lights on suburban?
Have you check all of the light bulbs? If yes, then check the ground next and then check the fuses. Lastly, if all of those check out, it is most likely the brake switch behind the brake pedal.
