Poor Airflow due to a dirty filter,dirty evaporator,dirty blower wheel, bad or weak run capacitor, or even a bad bearing in the fan motor causing it to overheat and shut off on overload while the compressor still runs, thus causing the unit to freeze up. On some systems it is possible that when the thermostat is satisfied and the indoor blower motor shuts off, the compressor could keep running if the contactor is sticking for 1 reason or another. Examples of this would be fireants or ladybugs in contactor or just an old contactor that has burnt points that stick some or all the time after running and getting hot. -Brad75-
form_title= Copper Tubing form_header= Have the supplies you need for all of your home improvement tasks. How much tubing do you need?*= _ [50] Will the tubing be used for liquids?*= () Yes () No Please describe the project in detail.*= _ [50]
id means inside diameter, od means outside diameter, copper pipe and tubing is measured by the od, therefore the od the pipe or tubing will be the same as the id of the fitting
The installation manual will tell you what size lines are acceptable.
Inside diameter just like copper tubing
K copper.
is it to restore full wall thickness
Copper Tubing Size, Outside Diameter controlled. - How copper and PEX tubing size is specified based on the outside diameter. Common sizes are 3/8, 1/2, and 3/4 inch. This contrasts to pipe sizing which is based on the inside diameter.
form_title= Copper Tubing form_header= Have the supplies you need for all of your home improvement tasks. How much tubing do you need?*= _ [50] Will the tubing be used for liquids?*= () Yes () No Please describe the project in detail.*= _ [50]
Depends if the copper tubing is annealed or drawn type as not all copper tubing if bendable
id means inside diameter, od means outside diameter, copper pipe and tubing is measured by the od, therefore the od the pipe or tubing will be the same as the id of the fitting
At what temp does pex pipe freeze
That's not going to work out very well for you.
tubing benders are the best used for
No is is only 99.999 % puure
The popular and proper mounting technique for copper tubing is a copper tubing clamp for the appropriate size. This clamp is made of copper and should be mounted with copper nails. It resembles a piece of tubing of the appropriate size, a half inch wide with two ears on either side with holes for nailing.
copper tubing
Copper tubing is best cut with a straight saw, ideally diamond tipped for the cleanest cut.