0
If everything else is good, like the fuel pressure ( sometimes the fuel pump in the tank stops ) wires. plugs etc. then the thing to look at is the Ign. module. It is on the distributor. "89's had that problem. You will have to pull the dist. to change the module. Not too expensive. The car will run fine then just stall. It will start again and run for a while till it happens again.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What is the firing order for a 1992 Mercury Topaz 2.3 l engine?
how to set timing on 92 ford mercury topaz 2.3 engine
Why would the engine start cutting out once you reach highway speed in a 86 mercury topaz?
If it is not fuel or spark, meaning loss of ign. spark, or fuel pump problems, then check the ign. module on the dist.
How do you replace the water pump on a 1992 Mercury Topaz?
what is the engine?
Does a 1993 Mercury Topaz have a timing chain?
On a 1993 Mercury Topaz : Yes , both the 2.3 litre four cylinder engine and the 3.0 litre V6 engine use a timing CHAIN
Where is a Mercury Topaz engine control unit located?
Not quite sure what you are looking for?
When was Mercury Topaz created?
Mercury Topaz was created in 1983.
Where is starter on 1986 Mercury Topaz?
open the hood, look down between the rad. and the engine. There it is.
Where is the oil pan located on a 1988 mercury topaz?
The oil pan is bolted to the bottom of the engine
How do you Replace the Horn on a 1993 Mercury Topaz?
Horn's should be in the fender wells in the engine compartment.
What is spark plug gap on 1992 2.3l mercury topaz?
According to one of Fords websites : For a 1992 Mercury Topaz , 2.3 litre four cylinder engine : ( the spark plugs are gapped at .054 inch )
Where is the oil pump located on a 1993 Mercury Topaz?
Inside the oil pan, mounted on the engine block.
Why would an engine overheat at intersections only on 1993 Mercury Topaz?
Evidently the cooling fan is not working.
