0
What else can I help you with?
What would cause starter to stay lockd in on position?
The starter relay (solenoid) points are melted together.
Why does the starter stay on after you start the car?
the starter should not stay engaged after the vehicle is running. more than likely the armuertor or the bendix is faulty. replace the starter.
Why does my Coolant light stays on on your 2000 Ford Mustang?
why does the coolent light stay on in my 2000 mustang gt 4.8
How long do starter lip piercings have to stay in?
they have to stay in 14 days C;
Does hawkeye stay with mustang?
Yeah of course they looked beast together!
Why would the starter stay engaged all the time after it and the solenoid were replaced on a 1986 F150 if no wires are crossed?
If this happened immediately after replacing the starter, I would say the wires on the solonoid are connected wrong. It could be the switch but I think it is the wiring.
Why does the starter for a four wheeler stay engaged when the key is off?
Starter solenoid is sticking. Replace it.
How long can sourdough starter stay in the fridge before it needs to be refreshed?
Sourdough starter can stay in the fridge for up to two weeks before it needs to be refreshed.
Why would the starter stay engaged after vehicle starts on 92 Topaz?
Either the ign. switch is faulty, or the starter is faulty Or the starter solenoid is stuck closed, so the starter is constantly engaged and getting voltage from starter relay. If so you would need to replace the solenoid.
Why does starter stay running after switch is off?
Either the keyswitch has failed or the contacts inside the starter have fused.
Where is the starter located on an 1990 eagle talon tsi 5 speed?
And instructions thanks to Autozone.com: Disconnect the negative, then the positive battery cables from the battery. For 1990-94 vehicles, remove the battery and battery tray from the engine compartment. For 1990-94 vehicles, detach the speedometer cable connector from the transaxle. Detach the starter motor electrical connections. Unfasten the starter motor mounting bolts, then remove the starter from the vehicle. Clean both surfaces of starter motor flange and rear plate. Install the starter motor onto the engine and secure with the retainer bolts. Tighten the retainers to the specifications shown in the accompanying figure. Attach the electrical harness connector(s) to the starter. If removed, install the intake manifold stay and tighten the retainers to 18 ft. lbs. (25 Nm). For 1990-94 vehicles, attach the speedometer cable to the transaxle. Install the battery tray and battery. Connect the positive, then the negative battery cables. Operate the starter to assure proper operation.
What weight oil do i put in my 1966 289 Ford Mustang?
ask the people ask the parts store but i would put ford MotorCraft in it stay offical with the car
