The problem would be in the linkage for the window or the run channel. It would be good to replace the run channel and lubricate ALL of the linkage. An auto trim shop will have run channel. Mine did that on my 93. I took off the door panel, took the three screws that held motor out. And found the motor gears shreaded. Went to AutoZone and for 40 bucks bought a new motor in stock. Plugged it in, put the bolts in, and lubed the gears. And in about an hour had the window working. =) Good luck!
does a 1991 thunderbird torque converter have a drain plug
My 1991 Mustang 5.0 LX came from the factory with ( 5W-30 ) I ASSUME your Ford Thunderbird would be the same
If it is a 5.0 from a 1991-93 Thunderbird/Cougar, then yes
Rear Window - 1991 was released on: USA: 1991
it is located on the steering column
the thunderbird sc has the firing order of 1-4-2 5-3-6
two one on each manifold
My 1991 5.0/H.O. was rated at @ 210 hp.
Thelma and Louise
On my 1994 Thunderbird, it's inside the left fender. I had to remove the splash shield to get to it. The 1991 is probably the same since all Thunderbirds from 1989 to 1997 used the same body platform.
1991 Chevy s10 how to replace outside window weather strip
under the dashboard black square thing
under the right side "kick" panel.
Thelma and Louise
I have a 1991 944S2 Cabriolet and still have the window sticker. The price on the window sticker is $53,000.
Probably a bad switch in the drivers door.
i would check for vacuum leaks first but there is an idle august screw on the air intake wear the throttle cable connects to the intake
Try removing the battery cables for a few minutes
the fuel pump is located on the fuel sender inside the fuel tank
what is the torque on the bolts for the transmission pan on a 1991 ford thunderbird 3.8
The American Woodshop - 1991 Window Bench was released on: USA: 15 November 2010
You can buy line by the roll and fabricate your lines & flare the ends.