0
Why would you have to know how to convert measurements when looking at a drawing?
Wiki User
∙ 11y ago
to know whether or not your info and the info your matching is alike. If not you need to convert one to check.
Annabel Jacobs
Add your answer:
Earn +20 pts
How do you convert 50 mg to ml?
That is not possible. This is because mg is a weight measurement, and ml is a measurement of volume. Only measurements of the same format may be converted into each other. If you knew what the density of the material was, you would be able to figure this out, however.
How would you convert 625 cu ft to square feet?
You can't convert a volume to an area
How would you convert 0.3 into a fraction?
if 0.3 is in the tenth place you place the three over ten and that is the way you convert it into a fraction.
What size of men's shoe does a women's size 9.5 convert to?
A 9.5 in women's shoes would convert to an 8 in men.
What would 233 hours convert to?
233 hours is 9.71 days.
Why would you have to know how to convert measurements when looking at a working drawing?
to know whether or not your info and the info your matching is alike. If not you need to convert one to check.
How you could change your drawing so that the side view would be more exaggerated?
Take the actually measurements in kilometers (km) and convert them to centimeters (cm) and record them so that the measurements will be more accurate.
Describe how you could change your drawing so that the side view would be more exaggerated?
In regards to drawing volcanos to show that the side-view would be more exaggerated you could add more 3 to 4 sided shapes.
How would you convert a measurement into pints?
It depends on what the measurements are.
How the range of commands used to produce CAD drawings can impact drawing or production?
C.A.D commands can impact a drawing production by allowing functions that would otherwise be impossible without the use of these commands. For example using the mouse to grab and rotate a design giving a 3D representation at any angle without having to start another drawing. Also by inputting measurements through the Keyboard C.A.D will convert your drawing precisely to those measurements eliminating the chances of human error. By doing this the completed drawing will have the exact measurement required. Another way C.A.D commands can inpact a drawing is by ..
What input would you use for drawing a cartoon?
Drawing tablets, drawing pen tablets are a wonderful way to draw whether it is about any cartoon, architectural work, measurements, drawing or any other art related work.
Which foundation drawing matches the orthographic drawing shown?
Amagine looking at a cube from an angle. Now to make that orthographic amagine looking at it straight. A cube would just be a square.
What are quantitative measurements?
Quantitative measurements are those which involve the collection of numbers. It is the opposite of qualitative data which are observations. For example, if you were interested in looking at height. Quantitative measurements would be taking an accurate measurement of everyone. Qualitative data would be looking at the person and putting them into a category of 'tall,' 'medium,' 'short.'
What are the measurements for A4?
If you are looking at the A4 paper portrait on the sides it would be 29.7cm and the top and bottom are 21.0cm.
How do you convert microns to daltons pore size?
Microns are a linear measure. Daltons are a measure of mass. As a result, these measurements should not be convertible. In order to equivalize these measurements it would be necessary that they be both of the same genre.
What is the scale and why scale must be considered when the draughtman drawing the plan?
The scale on a drawing represents the ratio of the size of the drawing to the actual size of the object. It must be considered to ensure accurate measurements and proportions in the drawing. Using the correct scale helps convey the information clearly and allows others to interpret the drawing accurately.
When laying-out receptacle and switch locations which type of drawing would take precedence for referencing receptacle location measurements?
An engineered set of drawings or blueprints would take precedence over all on an electrical project.
