Want this question answered?
A three phase motor looks like any other motor from the outside. It might be a little larger than a standard motor but it looks the same. If it is not hardwired but has a plug, the plug will have four prongs instead of three. The socket will look different from a standard socket or the socket for a stove or air conditioner. It will also have four holes. The hole for the ground plug will have a special indent. That makes it so you can not put the plug in wrong. A two phase motor will run the correct way regardless of how you put the plug in the socket. If you would put the plug for three phase motor in the socket the wrong way, the motor would run backwards.
it melts
it depends when you put it and depends that on how much you could put the water to what level it would be
no, water and water are the same thing. If you put it all together, you would still have water, nothing changed except for quantity.
It sounds like you have a three phase motor that you are trying to put in where you have a single phase 120volt motor. You can purchase a three phase inverter, but the cost will exceed the cost of the new motor sized for the right wiring and voltage.
coil the hose and put it in a bucket of warm water..or if no warm water put in some water..
you must first put on your yamaha hose adapter for your garden hose. then without turning the water on plug the hose into the yamaha. there should be a place to put the hose in the engine compartment. then start your engine the turn the water on. make sure the water never on when the engine is off. let the pwc run at idle speed for 240 seconds (4 mins). then turn the water off and shut down your engine. gracias
Hose and you tell a Girl to put her mouth on the end of the hose and when her mouth is on the hose you sticky tape around it and then when you are finished take a photo of the girl with a hose in her mouth and then you turn on the hose and all the water will pour into her body and she will be a Water Balloon.
You would have to put a casing around it, find a different incoming water hose, and adapt the drain hose.
Connect a hose to your faucet and turn it on, put the hose in the water.
i have a 02 and replaced blower motor myself 22.00 dollars 4 new motor at auto zone pasenger side under the hood on the fire wall 4 little screws and one conector also a little hose pull hose out pull motor out a cricle clip pin holding fan on 2 motor pull off remove fan replace on to new motor put hose on new motor slips on easy put motor back into place screw 4 screws back on put hose on conect conector you are now finshed and replaced your blower motor for under 25.00 dollars good luck
antifreeze keeps your car from overheating, it flows thru your radiator hose, without it your motor would blow
top radiator hose, Engine side, metal nippile that attaches hose to motor,,,,,,,,,,,,,, Its under the nipple Top radiator hose,, engine side,,metal nipple that attaches hose to motor,, its under the nipple,,,,,,,,,,,,,,,,, be sure to put the new t-stat in with the larger brass side toward the motor.
your skimmer basket is full and it is not takink in any water. put water in your pool with a garden hose.
Flush all coolant from system by loosening lower rad hose (when cool) and catching all fluid with a bucket. Use a garden hose to flush radiator from upper cap. When drained and flushed fill with 50/50 coolant/water.
follow the radiator hose that goes to the motor, the thermostat housing is the thing the hose is hooked to and it is bolted to the motor with three bolt i believe. you take the hose off, the housing off and just take the old thermostat out and put the new one in.
they uses a hose and some water