If, by 'upf', you mean 'unity power factor', then allwattmeters measure the in-phase component of the load current, so the term is quiet unnecessary.
A short-circuit test is used to determine the (true) power loss in the transformer, which is exactly what a wattmeter measures
Yes, there is a difference between single phase and three phase circuits.
In a single-phase circuit like a house fed from 4-wire three phase in the street, the current flows in the live and neutral wires. The neutral currents from a street of houses are expected to cancel each other so that the overall current in the neutral leaving the transformer is small.
An open-delta connection is a method of providing a three-phase supply, using two single-phase transformers. It is particularly useful if , say, one single-phase transformer, part of a three single-phase transformers forming a three-phase transformer bank, becomes damaged -allowing the two remaining transformers to provide a temporary three-phase supply to the load. The drawback with this connection is that the capacity of the transformer bank is reduced, and it can only provide a lower load current.
Procedure for sumpners test is the single phase transformer. This is a back to back test.
This is the rated output of the transformer, obtained by multiplying the rated secondary voltage by the rated secondary current. And it's 'kV.A', not 'kva'.
Open circuit and short circuit tests are performed to determine transformer characteristics. In the case of a single phase transformer, SC tests would be performed to determine the impedance. The open circuit test will give excitation information (% excitation at specific voltages, often 90%, 100% and 110%, and no load losses).
Your best bet is to go to Acme Transformer on the web and once you are on their web page select how do I rate a transformer, they have everything single phase 3 phase step up step down.
This depends on the voltage, and whether it is a three phase or single phase transformer.
By having a transformer with 3 phase input and single phase out put
In series to every phase winding of transformer.
Harmonics are really not needed in single phase transformers.
Your question is rather vague. If you are asking what do you call a group of single-phase transformers, connected to supply three phase, then the answer is a 'three-phase transformer bank'.
See Discussion Page
A single-phase transformer works with a single-phase supply, while a 3-phase transformer is used with a 3-phase supply. A single-phase transformer has 2 wires on the primary and secondary (ignoring taps) while a 3-phase tansformer has 3 or 4 wires on the primary and secondary.
single phase have 2 wire treephase have 3, and 4 wires
yes we can use as a single phase circuit because at practise directly the 3-phase circuit is made by combining the three single phase circuits
By design are you going to wind the transformer yourself? In your design you need a 5:1 ratio. On the output side of the transformer any two legs of a three phase transformer is considered single phase voltage. Good luck on your project.