check the vacuum hose that goes to the actuator;usually located under the battery holder.If not the problem check the cable that is attached to the actuator to make sure it is clipped tight.that cable runs to front pumpkin.
place car in neutral , then bring lever down to 4hi position , then put car in drive.
The GMC Jimmy is rear wheel drive. The only time the front wheels pulled is if it was a 4x4.
How do you engage four wheel drive on 1995 Chevy S-10?How do you engage four wheel drive on 1995 Chevy S-10?
when i try to engage the wheel wheel drive it grinds i have my truck in neutral what could be the problem what am i doing wrong
could be the 4 wheel drive module located behind the glove compartment. If you don"t hear a click when you press the button to engage the module isn't working.
If you have a lever, pull it into the four wheel drive position. If a switch, put in four wheel drive.
If it has 4-wheel drive you would see controls on the dash to engage 2-wheel high, 4-wheel high or 4-wheel low.
No. It is standard rear-wheel drive truck until the 4WD mode is engaged.
I have replaced the vacuum diaphragm for the 4 wheel drive. Now the 4 wheel drive works intermittenly. Why? I have replaced the vacuum diaphragm for the 4 wheel drive. Now the 4 wheel drive works intermittenly. Why?
NO !
Simply pull the four wheel drive lever back towards the seat.
push the four wheel drive button on your dash, see owners manual