I think you mean a d.c. power supply, not a transformer which is an a.c. device. The rule is that the power supply's voltage must match that of the load, but its current rating must exceed that of the load. So it is perfectly fine for a 12-V 2.5 A power supply to be used with a 12-V, 1000-mA load (it is the load that determines the current drawn from the power supply).
Depending on what is connected. Check the specifications for what you're using the transformer for - is 2500mA needed, or is less than 2000mA needed? If more than 2000mA is needed, your transformer will overheat and fail eventually, so it's not a good idea. Bigger is always safer.
Depends on the load being run off it. If the device you're powering off it draws less than 2 amps, then yes.
Use a transformer.
A single phase 600 to 240 Volt transformer using two phases of the three phase primary.
any one of the three line to neutral is 220 volts
200 and 100
A transformer's capacity is rated in volt amperes(V.A). This is the product of the secondary winding's current rating and voltage rating.
A: YES the higher the number the better it is for conduction . But never the other way around
yes
Yes.
If the load you are connecting to the transformer uses 1.5 amps or less, yes.
No, it will destroy the 3 volt device.
step up transformer
Use a voltage devider or a transformer.
AC voltage is more sufficient than DC voltage. Moreover, an AC transformer can be developed but DC voltage will make it harder. Without a transformer, we cannot turn the high and low voltaged into each-other.
By the volt metre.
The conductor for H2 connection on a 480 volt wire transformer should be marked:
3
You have to buy a transformer or converter from 220v to 110v.