Yes a 208 voltage motor will operate on 220 volts. You have to increase the motor overload protection by 10% of the motor's full load amperage to protect the motor.
It would work but it would probably run 20 per cent faster, so if that is not a problem it's OK. But if the load is a fan, the motor might not be able to supply the extra mechanical power at the extra speed, so it would run but it would overheat.
Yes it would work pretty well but it might not meet its accuracy specification.
If the motor is connected to an ungrounded delta supply service there will be no effect on the operation of the motor. If the motor is connected to a wye system supply service and the B phase grounds out, the motor's overload protection would take the motor off line from the electrical supply.
A synchronous motor can be a type of 3-Phase AC motor, or not.A synchronous motor is defined by the period of the rotor being synchronized with the frequency of the stator windings' current. The stator windings might be 3-Phase or not (2-Phase would work).Also synchronous motors are not the only type of 3-Phase AC motors. An induction motor could also be 3-Phase AC and has a few advantages and disadvantages over a synchronous motor.
Sorry, won't work. You need a 110 volt supply.
It would work but it would probably run 20 per cent faster, so if that is not a problem it's OK. But if the load is a fan, the motor might not be able to supply the extra mechanical power at the extra speed, so it would run but it would overheat.
If the motor is 3-phase (it will say so on the nameplate), you don't need a diagram. just hook up all 3 wires in any order. If the motor runs the wrong direction, swap any two of the phases. This is true for all 3-phase motors. Its that simple! Warning: this obviously will only work if you have 480v, 3-phase power available. If you are trying to do this at home, it almost certainly won't work, because homes (in the US) typically have 240v 1-phase power. Trying to run a 3-phase motor directly on single phase power will destroy it. There are various ways to convert single phase power to three phase, but if you are having a hard time just hooking up the motor, they are beyond your ability at this time. Get a qualified electrician to help you! It could save your motor, and quite possibly your life!
A three phase motor will not operate on single phase. The motor will run on two phases but will not start. Motors running on just two phases is called single phasing. The line current of the two legs will go high and it is this factor that the motor controller uses to trip the contactor to open the circuit and isolate the motor from the power source.
The winding design of the motor will not economically allow this to work. You would have to drive a 3 phase generator to supply it.
a three phase motor will work
Yes it would work pretty well but it might not meet its accuracy specification.
no
The voltage of 120 volts is more common that the lower voltage of 12 volts.
The motor cannot be altered to work on single phase power. You will either have to put in a new single phase motor or use a phase convertor box. Do a google search for phase convertor - you will find plenty.
yes the motor will rotate but less then the rated speed and more heat will be desipated
usually what causes that is the blower motor resistor. Get a volt meter and test it according to it's values, 90 percent of the time it's the RESISTOR.
If the motor is connected to an ungrounded delta supply service there will be no effect on the operation of the motor. If the motor is connected to a wye system supply service and the B phase grounds out, the motor's overload protection would take the motor off line from the electrical supply.